The mass air flow (MAF) sensor on a 2003 Toyota Echo is located in the air intake system, specifically between the air filter box and the throttle body. To access it, you'll need to remove the air intake duct that connects these two components. The sensor is typically housed within a plastic housing that can be unbolted for inspection or replacement. Always ensure the engine is turned off and cool before attempting any maintenance.
It's electronic.
It doesn't use a Map sensor , it use a MAF sensor , and it is located right on top of the Air filter box
Inside the fuel (petrol) tank.
On a 2003 Toyota Echo, the crankshaft position sensor is located on the engine block, near the bottom, typically on the driver's side. It is positioned close to the crankshaft pulley, often mounted on the front of the engine. To access it, you may need to remove some components for better visibility and reach. Always refer to a repair manual for specific instructions and diagrams.
On a 2003 Toyota Echo, the crank position sensor is located at the lower part of the engine, near the crankshaft. Specifically, it is typically found on the engine block, close to the transmission bell housing. To access it, you may need to remove some components or covers, as it can be somewhat hidden. Always consult a repair manual for detailed instructions and diagrams specific to your vehicle.
Under the dash, on the passangers side.
On top of the engine, but you have to remove the cover to see them.
If the AC stopped blowing air on your 2003 Toyota Echo, the blower fuse could be to blame. If the fuse is fine, it might be the blower resistor that needs to be replaced.
chain
The one closest to the exhaust manifold is the upstream O2 sensor.
You can get a refurbished one for about $70. See: http://lmgtfy.com/?q=toyota+echo+mass+airflow+sensor
On a 2001 Toyota Echo, the knock sensor is located on the engine block, typically near the cylinder head. It is usually positioned on the side of the engine, often on the driver's side, and can be accessed from underneath the vehicle or through the engine compartment. To replace or inspect it, you may need to remove some components for better access.