0
What else can I help you with?
How do you repair egr valve on 2001 Saturn sl2?
You clean or replace it.
What parts do you swap from 97 sl2 engine to a 95 sl2?
The only hard part is the EGR valve assembly. The head on the newer Saturn is slightly different, making it necessary to find a work-around for the EGR valve.
Why would a 1993 and a 1995 Saturn SL2 both surge ahead and then want to die when driving them even after replacing many parts?
Did You replace the EGR valve! Happened to me!
Where is the EGR valve on your 2000 Saturn sl2?
On the back of the head, just above the transmission bell housing,
Where is the egr valve pressure sensor on a 2001 Saturn sl2?
There is no pressure sensor. The EGR valve is located on the head next to the battery. Cleaning it is usuallu the first step if there are any SES codes associated with the valve.
How much would a valve cover gasket be for a 1995 Saturn sl2?
25-35 bucks
1994 Saturn sl2 changed egr valve but still smell gas?
I'd start with the basics; see if there is a fuel leak.
How do you replace the PCV valve on a 1995 Saturn SL2?
The PVC valve is not held in by any nuts or bolts. Just pull on it to remove it.
Where is the EGR Valve on a 1999 Saturn SL2?
The EGR Valve is located on top of the intake manifold. If you are standing in front of the car it would be on your right hand side. It is cylinder in shape and has wire harness that connects to the back of the engine!
How do you install a valve body into a 1995 Saturn sl2?
Check out sunbelt valve body builders they specialize in saturns. Their number is 813615560 or at sunbeltvalvebody.com
How do you replace an EGR on a Saturn sl2?
Depending on the year, the EGR valve is easily removed by removing the electrical connector and the bolts. Looking down at the engine from in front of the vehicle, the EGR valve is connected to the right side of the head, just above the transmission bell housing.
Where is the EGR valve located on a 1998 Saturn SL2?
EGR valve is located on the top of the motor, just to the right of your valve cover, in between the valve cover and the air intake tube. it has a 4-wire connector going to it. Besides the wire harness, the valve is held in by two 10mm bolts.
