Where is the PCV located on a 2000 Chevrolet S10 4.3L?

The 2002 Chevrolet PCV valve is located on the outside of the air intake housing. The valve will be on the back of the housing.

Its not A PVC Its A PCV Value Its not A PVC Its A PCV Value

In the valve cover.

Pull upward on the hose that the PCV valve is in. The PCV valve will pull out of the hose. The PCV valve is located in the valve cover.

It is located in the right valve cover.

You did not say what size engine but in most cases the PCV valve is in the valve cover.

For the 305 (LO3), the PCV valve is located on the driver's side valve cover. It's held in place with a rubber grommet.

On top of the air filter is a diagram that shows you where the PCV valve is located.

It is located in the valve cover.

The PCV valve is located in the rear valve cover,just behind the throttle body

drivers side rear valve cover. top.

The PCV valve on a 2000 V6 Camry is found near the engine. More specifically, it is located on the top of the valve cover.

Try looking on the head, on the passenger side of the throttle body

On a 2000 Durango V8 the PCV is located on the side of the oil fill tube under the cap

The PCV valve is located in the rear valve cover,just behind the throttle body

It's on the throttle body.

At the outlet to the fuel injection hose.

on the valve cover

The PCV valve is located under the black plastic shroud on ther drivers side on top of the intake manifold. It will be covered by a circular foam insulation.

its located on top of the valve cover. its located on top of the valve cover.

It doesn't have a serviceable PCV Valve. It is built into the valve cover.

On the engine valve cover on driver side.

need to know the size of the engine

mine is in the glove box.

On a 2000 Ford Ranger , 4.0 liter EFI , V6 engine : The PCV valve is on top of the drivers side engine valve cover It is near the rear of the valve cover ( towards the firewall end )

The pcv valve is located in the valve cover on the top of the motor. It has a black hose connecting it to the intake manifold.

It is located in the valve cover. There will be a large vacuum hose that goes to it. Always purchase a quality valve as it is very important for crankcase ventilation.

Not too sure about the 3.9L, but the 3.5L has none, just a nipple on the valve cover...

PCV valve is connected to the valve cover, the one closer to the radiator. You can identify it by tracking a vacuum hose coming out of the cover.

IT IS LOCATED ON DRIVERSIDE REAR OF VALVE COVER ON THE CORNER

The PCV is located on the drive belt side of your vehicle ( the front passanger side ) near the intake manifold. This part is very difficult to remove; it is attached to a breathing device.

It's located at the end of 2 hoses. One hose goes into the top of the engine and the other hose goes into the end of the air cleaner. Between the 2 hoses the PCV is located in a vent tube.

Usually it is either a screw on cap in a valve cover or you're expected to yank the PCV filter out of a valve cover.

On a 2000 Ford Ranger , 4.0 liter EFI , V6 engine : The PCV valve is on the drivers side engine valve cover , on the top of the valve cover , near the REAR of the cover

In the intake behind the throtle body.

It is located underneath the throttle body.

PCV Valves are located on either the Left or Right Manifold of the engine. Simply unplug the old one and inster the new one. HTH

The PCV valve is located directly ontop of the engine block and is connected by a rubber hose on one end connected into the engine with the other end you will find it on the lower right (topside) of the engine : D

It is threaded into the valve cover. There is a rubber tube that attaches to the valve cover - pull off the tube (there may be a clamp) - then unscrew the PCV valve with a wrench.

On my 2000 E150 with 4.6L engine, the PCV valve fits in a rubber grommet in the center of the valve cover, with an insulated line running to the intake manifold.

the pcv will be located on the top of the valve cover with a 3/8th vaccume line connecting to it

The PCV valve is just to the left of the carberator...if your looking at the carb. follow the hose comming out of the center of it (should be rubber and hard plastic combo) that plugs into the PCV valve. I believe the answer is that it does not have one...I have a 2000, and it doesn't have one......

The PCV valve is located in the valve cover

The pcv valne is located is located right near the alternator in the 1993 Bonneville.

The 2005 Chevrolet Up to land or PCV valve can be found near the back of the engine. The PCV valve will be behind the air cleaner housing.

It's located on top of the valve cover - note that it's not a rubber PCV valve like a lot of other cars, it's fully metal, and costs a little more. I got my new PCV valve in Advance Auto parts (My local Autozone had one that did not match what was on my car.

The Positive Crankcase Ventilation (PCV) valve is located in the valve cover. The PCV system consists of a hose leading from the valve cover to the intake manifold and a fresh air hose from the air cleaner assembly to the rocker arm cover. from the Haynes Repair Manual 1998-2002

It's in the intake one of the bigger hoses that go in. You have to use a wrench to remove it.

The 4 cylinder has the PCV located under a threaded cap that is screwed into the valve cover on the back side. You will need to remove the vacc. hose from the cap and then unscrew the cap and remove the PCV from the hole that is opened up and replace the valve and install the cap and hose. It will be oil covered and that is normal.

where is the pcv valve located on a 2003 Nissan sentra