answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2011-09-13 11:04:20
2011-09-13 11:04:20

where is the pcv valve located on a 1995 Isuzu rodeo v6 3.2l

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


How do you adjust the valves on a 1995 isuzu Rodeo 3.2


The PCV will be located somewhere on the engine block. It will have a wire attached to it and it will be on the top of the crankcase, covering the valves.


It is located under the timing belt cover.


The diagnostic port on a 1995 Isuzu Rodeo drive is located on the lower kick panel on the driver's side. It is just below the left spark plug.


Hello... what is the original size of the muffler that came with a 1995 Isuzu Rodeo lengh etc...


The 1995 Isuzu Rodeo will have one dipstick ?æon top of the engine, this is the oil dipstick. ?æThe transmission fluid is adjusted from beneath the car.


Hi, How Do You Replace a Starter on a 1995 Isuzu Rodeo, V6, 3.2 liter engine? Does anyone know where the starter is? Help. How Do You Replace a Starter on a 1995 Isuzu Rodeo, automatic, 4wd, V6, 3.2 liter engine? Does anyone know where the starter is? Thanks alot.


it will fit but you will have to get new hoses for the correct sizes


its on the drivers side kick panel





No it is not, in 1996 Isuzu bumped the horsepower of their 3.2L V6 up to around 195 hp and 193 ft·lbf of torque for the 1996 and 1997 Rodeos continuing into 2004 in which Isuzu operated here in the states under GM dropped the Rodeo line


The 1995 Isuzu Rodeo has a curb weight of 4,110 pounds. The vehicle gets 15 miles per gallon in the city and 18 miles per gallon on the highway.


The manual transmission that came in 1995 Isuzu Rodeo was 21.9 US gallon engine which was ranked as 18mpg-US. This has been modified over the years with most models having automatic transmission.?æ



goto www.ecoustics.com I found one for 96-97 for my rodeo on there!! Good luck the colors aren't right


its on the end of the wires just above the air filter housing unit


on the themostat housing where the upper rad hose meets the intake manifold




A 1995.5 model has the updated interior similar to a 1996 model, but has the same drive-train as a 1995.


I think your valve cover gasket may be letting oil leak out onto the hot engine. It then "burns" off releasing the smoke you refer to. If you replace the valve cover gasket it should correct the problem.


Take old spark plugs out put new spark plugs in


One (1) each on the cam and crank gears and on the outer timing case.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.