no the egr valve has a big effect on the engine,it is controlled by the pcm.
mine is in the glove box.
No, the last year for a 3400 motor in a Camaro was 1996.
It is located on the passenger/right rear side of the engine, near the oil filter.
i have the 3.4 liter 2000 impala and its up against the top of the firewall towards the middle of the engine
about 2000 if your lucky
tell me where is the egr valve located please the egr valve is usually located on the top right of the intake manifold on top of the engine so if your facing the engine, look down to your right
Left Side of the engine: in the sensor case attached to the vacuum hoses
There are plenty of engines that can fit in a 2000 Chevrolet Camaro. Some options include: LS1, LS2, and LS3 motors.
Oil capacity? 5 quarts
Where the motor and trans meet on the driver side
Even though GM still claims this is a "Small Block" the last of the real small blocks was built in the 2000's
Yes. I sold several of them.....chuck
It will be on the back top of the drivers side valve cover.
Around 325 hp.
The PCV valve for a 2000 Lexus rx300 is on the passenger side of the engine. It is on the valve cover near the back.
on a 2000 3.1 it is on passenger side between firewall and engine!! if a four check right by right strut tower. the cap has an "L" on it!!
Technically no, but I have seen valve hit valve when the timing belt breaks.
On a 2000 Ford Ranger , 4.0 liter EFI , V6 engine : The PCV valve is on the drivers side engine valve cover , on the top of the valve cover , near the REAR of the cover
The 2000 5.9 liter Cummins engine E GR valve can be found on the air cleaner housing. The valve is usually on the back of the air cleaner housing.
The EGR valve on a 2000 Chevrolet Lumina is located inside the intake manifold. A replacement valve can be purchased at any auto parts store.
The PVC valve on a 2000 Hyundai Accent enters the head of the engine. It can be seen by the air manifold towards the driver side of the engine.
Not without extensive (and expensive) modification