The starter on a 1988 Chevy Celebrity is located on the bottom of the block at the bellhousing.
The fuel filter on a 1988 Chevy celebrity 2.5 litre FI is located right in front of the rear passenger side tire.
what is the wiring diagram for an 1988 Chevy celebrity stero
The coolant fan relay on a 1988 Chevy Celebrity with 2.8L V6 is on the radiator support bracket behind the right hand headlights.
The fuel filter in your 1988 Chevy Celebrity is on the driver's side behind the rear wheel next to the fuel tank.
The fuel pump on your 1988 Chevy Celebrity is in the fuel tank.
The flasher on your Celebrity is located on the fuse block. The fuse block is on the bottom of the dash to the right of the steering column.
The 1988 Chevy Celebrity uses distributorless ignition. There is no provision to alter timing, the engine control module takes care of that.
To locate the thermostat on a Chevy Celebrity follow the upper radiator hose to the coolant outlet, which is mounted to the top of the thermostat housing.
..the oil filter is located under the engine , centered approx. 4 inches back from the radiator.
In the fuel tank
100 lb or above
It is inside the alternator.
The PCV valve on a 1987 - 1990 Chevy Celebrity is in the top center of the valve cover nearest the firewall.
No easily, however, I suppose you could.
Other than the 1987 and 1988 Eurosport VR versions I am unaware of any Chevy Celebrity with cup holders.
Any Auto Parts Store.
No, there is no camshaft sensor on that model.
If you are asking about the heater blower motor it is mounted to the heater ducting in the engine compartment on the passenger side.
The firing order on all Chevy Celebrity V6's is: 1-2-3-4-5-6
In a 1988 Chevy pickup the ECM is located behind the glovebox.
check your fuses
For a new or rebuilt oil pump for your 1988 Chevy Celebrity 2.5L check with an automobile parts store.
were is the fuel regulator located on a 1988 chevrolet celebrity ? The fuel pressure regulator is located under the intake manifold on the 2.8 V-6 engine but the pressure (Schrader type) test valve port is on the front of the engine to the right and just below the oil filler cap.