Chrysler Sebring

Where is the blower motor resistor on a 1998 Chrysler Sebring?

212223

Top Answer
User Avatar
Wiki User
Answered
2008-02-21 05:19:02
2008-02-21 05:19:02

Fig 15 Blower Motor Resistor

NOTE: The blower motor resistor is located on the lower right side of the heater housing.

REMOVAL

# Remove lower right underpanel silencer/duct. # Disconnect wiring connectors on blower motor resistor. # Remove blower motor resistor retaining screws. # Pull blower motor resistor out of heater housing.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The blower motor resistor has failed.The blower motor resistor has failed.

It is under the dash on the passenger side.

under the dash. if you can find the blower motor then it should be right above that

The blower resistor is probably bad, due to a failing blower motor that is drawing too many amps.

The usual cause is a failed blower motor resistor.

The most common cause is a failed blower motor resistor.

Blower motor resistors are usually located close to the blower motor.

The blower motor resistor is over the passenger side strut tower, under the hood.

The blower motor resistor location on a Chrysler 300M is on the passenger side of the vehicle. It is on the floorboard next to the inside firewall, just in front of where the passenger sits.

The blower motor is located in the same area as the resistor, it's held in with 3 screws. Removing them will allow the motor and wheel to drop down.

The blower resistor is behind the glove box. It mounts to the HVAC housing.

It is under the dash, far passenger side.

It is under the dash on the passenger side.

A malfunctioning blower motor resistor will cause the blower motor not to work. When the resistor is bad the blower motors will not turn on.

It is under the dash on the far passenger side.

usually by the blower motor -- look behind glove box area or under hood near blower motor

its under the dash on the passanger side, look for it next to the blower motor, it has 5 or 6 wires and is held into place by 2 small screws 8mm if I remember right, its a 15 min job

On an auto temp system the blower motor resistor has failed and needs replaced.

The a/c heater blower motor resister is located in the vehicle on the passengers side inside the housing next to the blower motor...............Remove the blower motor resistor wire harness connector.Remove the blower motor resistor screws.Remove the blower motor resistor.

Generally the blower motor resistor is found close to the blower motor. It relies on the blower motor to keep it cool.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.