If the level is slack, then the bonnet release cable has snapped.
You'll have to jack the car up, and access / pull the cable from underneath.
To open the bonnet on a 2003 Fiat Punto, first, locate the bonnet release lever inside the car, usually found on the driver's side near the footwell. Pull this lever to release the initial latch. Then, go to the front of the car and find the safety catch under the bonnet, which is typically a small lever or tab in the center. Lift the bonnet while pressing the safety catch to fully open it.
To replace the bonnet release cable on a 2000 Fiat Punto, first, open the bonnet using the manual release if possible. Disconnect the old cable from the release lever inside the vehicle and the catch mechanism at the front of the car. Install the new cable by routing it through the same paths and securing it to the lever and catch. Finally, test the new cable to ensure proper operation before closing the bonnet.
AnswerThe Bonnet is called the Hood in the U.S. Pull the lever inside the car, on drivers side. Then release the hood (bonnet) with the lever located in the front grille.If the level is slack - it points to a snapped bonnet release cable.To open the bonnet in this situation (on a Fiat Punto), you'll need to get under the car.I jacked up the car, placed it on a stand on the passenger side, and reached up underneath. I've videoed it - quick to do once you see it.http://bit.ly/Yh1dQ9TAG: Fiat Punto, Bonnet Cable, Snapped Bonnet Cable
Pull the handle on the drivers side to release it and then put your hand - palm up - through the gap at the front of bonnet in the middle so your fingers can lift the final release handle. If the gas struts are u/s then it will be very heavy to lift.If the level is slack - it points to a snapped bonnet release cable.To open the bonnet in this situation (on a Fiat Punto), you'll need to get under the car.I jacked up the car, placed it on a stand on the passenger side, and reached up underneath. I've videoed it - quick to do once you see it.Go to related links below.http://bit.ly/Yh1dQ9TAG: Fiat Punto, Bonnet Cable, Snapped Bonnet Cable
There should be a cable hanging down from where the latch was. Just grip with a pair of pliers and give it a gentle pull. You will hear a click and then you can release and go to the front of the car and open the bonnet.If the level is slack - it points to a snapped bonnet release cable.To open the bonnet in this situation (on a Fiat Punto), you'll need to get under the car.I jacked up the car, placed it on a stand on the passenger side, and reached up underneath. I've videoed it - quick to do once you see it.http://bit.ly/Yh1dQ9TAG: Fiat Punto, Bonnet Cable, Snapped Bonnet Cable
On a 1997 Fiat Punto, the bonnet release cable is typically located inside the vehicle, near the driver's side footwell. You should find a small lever or handle that you can pull to release the bonnet. After pulling the lever, you may need to manually lift the bonnet slightly to disengage the safety catch. If you're having trouble locating it, consulting the owner's manual can provide specific guidance.
The latch release lever is on the driver's side on the floor next to the door. If the level is slack it points to a snapped bonnet release cable. To open the bonnet in this situation (on a Fiat Punto), you'll need to get under the car. Jack up the car, placed it on a stand on the passenger side, and reached up underneath. Watch the video: http://bit.ly/Yh1dQ9
not 100% sure but it could be under the bonnet on the right hand side
this holds the cooling fluid for the radiator
this is usually caused by the bonnet release cable getting stuck. try pushing and pulling the bonnet release lever inside the car.
Fiat Punto was created in 1993.
fuse for power steering on fiat punto if your looking for the fuse under the bonnet big black box on the right open up the box and you will see the big blue fuse in the middle of the top row .