on the v6 1997 lumina ,the camshaft sesor is on top of engine right behind the power stiring pump,very small space just follow the four wire plug on top of engine ,plug wires lead right to sensor.i hope this helps you.
the back
where is the oxygen sensor located on a 1997 Chevrolet lumina
The 1999 Chevy Lumina 3.1 liter engine crankshaft position sensor is located on the back of the crankshaft. A diagram can be obtained from most Chevrolet dealerships.
The Chevy lumina does not have an inertia switch.
On a 1993 Chevrolet Lumina, the camshaft position sensor is typically located near the engine's camshaft, often mounted on the engine block or cylinder head. Depending on the specific engine variant, you may find it near the distributor or at the back of the engine. To access it, you may need to remove some components for better visibility and reach. Always refer to a repair manual for your specific model for precise details.
It is located in the transmission.
The EVAP canister on a 1996 Chevrolet Lumina is located under the rear of the vehicle. The spare tire has to be removed to reach it.
Inside the tank.
If its like the 1993 Lumina it's in the fuel tank.
Chevrolet Lumina was created in 1989.
in gas tank
The battery is located under the hood on a 2000 Chevrolet Lumina. The battery will be on the drivers side.