Cam Postion Senor in a 92 is located inside the Distributer. Under the rotor. You can see the plug that goes to it on the under side of the Dist housing.
The camshaft position sensor on a 1992 Buick Regal looks like the end of a ratchet.
it should be in the distrubator
Some of the 1992 Rangers had the camshaft position sensor on top of the engine in the same hole where the distributor used to be. Some Ranger engines did not use a camshaft sensor at all.
inside of the distributor
The camshaft position sensor, which is located inside the distributor, is a pretty easy component to test on the 1992-1995 5.2L/5.9L Dodge Ram 1500/2500 pickup.
where does the camshaft sensor go in a 1992 Cadillac Sedan Deville?
Answeron the rear of the engine, towards the transThe cam sensor is in the distributor.
It should behind the crankshaft pulley, just next to the timing belt gear.
If you have the V-6 engine it is on the side of the engine block closest to the firewall just above the oil pan about 2 inches up and about middle of the block. This is the crankshaft sensor this car does not have a camshaft sensor On the 4 cylinder it is below the coil pack same side of the engine as the V-6. And again this is a crankshaft sensor not a camshaft sensor. Hope this helps
On the front of the engine block on the drivers side of the engine. Right below the valve covers.
Under hood, passenger side, lower engine area, below water pump, mounted on timing cover.
It is located lower right hand side of engine unfortunately you will have to remove the distributor assembly to install as it is integral.