Oxygen Sensors
Chevy Monte Carlo
1995-2005 Chevy Cavaliers

Where is the camshaft sensor on a 1995 Chevy Monte Carlo?

101112

Top Answer
User Avatar
Wiki User
2011-09-13 10:35:12
2011-09-13 10:35:12

i do believe that the camshaft sensor on the 3100 v6 motor is on the passeger side of the motor underneath the intake manifold and under the powersteering pump. i needed to replace the one on my 1996 lumina with that same motor and that's where i fould it. hope this helps.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

right behind and below the power steering pump on the block.

User Avatar

on the 3.1, it is under power steering pump. remove pump set aside ,do not remove hoses.once removed sensor is reachable!! there should be one bolt to hold sensor in!!

User Avatar

There is no such thing as a 2008 Monte Carlo, so the answer would be no.

User Avatar

Water pump removal chevy monte carlo 3.8

User Avatar

Where is hood open sensor on 2006 Monte Carlo

User Avatar

where is the crankshaft position sensor on a 2003 monte carlo

User Avatar

It is located to the right of the throttle body. It is square shaped.

User Avatar

Where is the oil sending unit at for a 2005 chevy monte carlo

User Avatar

How do i replace the purge valve on a 1999 Chevy Monte Carlo

User Avatar

There will be no 2007 Chevy Monte Carlo. The Monte Carlo has been discontinued and 2006 was the last production year. There are 2007 Monte Carlo's. They may have been made in 2006 but there are 2007 models.

User Avatar

On a 2000 Chevy Monte Carlo it is along the frame rail on the drivers side

User Avatar

Where is the O2 sensor on 1997 Chevy Monte Carlo 3.1 litter with 8th digit vin M

User Avatar

what other chevy make has the same fuel pump as the 1997 chevy monte carlo

User Avatar

How do you install a new heater core on a 1979 chevy monte carlo?

User Avatar

There is no such thing as a 2008 Monte Carlo

User Avatar

Depends on what engine and what year Monte Carlo you're referring to...

User Avatar

The speed sensor on a 1984 Monte Carlo is located on the output shaft. The speed sensor is typically driven by the gear of the vehicle.

User Avatar

yes next to tjhe oil filter on a 1997 monte carlo

User Avatar

On the passenger side of the radiator about half way down.

User Avatar

Here is an excellent diagram, includes location and replacement instructions: http://www.justanswer.com/questions/29v0n-how-do-you-change-a-speed-sensor-in-a-2005-chevy-carlo

User Avatar

where is the vaccum canister located on a 96 monte carlo

User Avatar

Last year they were made was 2007...there is no such thing as an 08 Monte Carlo

User Avatar

were is the bcm located on a 2000 monte carlo

User Avatar

how due you vhange a inner and outer tie rod on a 2001 Chevy Monte Carlo

User Avatar

Where is the knock sensor on a 2000 monti carlo ss 3.8l


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.