It is below the injection pump on the back side of the front cover.
1997 Dodge diesels come with the 12 valve cummins engine. It is fully mechanical and does not have a camshaft position sensor. "Dodge cummins diesel forum" is a good resource for dodge cummins owners.
The 2005 Peterbilt M 11 Cummins diesel engine map sensor is located next to the fuel pump. The map sensor should be labeled as such.
A 1997 Dodge with a Cummins diesel does not have an oxygen sensor.A 1997 Dodge with a Cummins diesel does not have an oxygen sensor.
Behind the camshaft vernier wheel on the Z19DT 120 engine
In 2004, the Dodge Cummins Diesel was not equipped with an oxygen sensor. The 2007.5 and newer Cummins 6.7 liter Bluetec diesels have an O2 sensor in the downpipe. Typically, only particulate filter equipped diesels have O2 sensors.
The camshaft sensor on the 7.3 engine is mounted on the front of the motor. It is just above the crankshaft damper.
In a 1996 Dodge Cummins Diesel, the coolant temperature sensor is typically located on the engine block, near the thermostat housing. It is generally found on the driver's side of the engine, attached to the cylinder head. This sensor monitors the engine's coolant temperature and sends signals to the engine control module (ECM) for proper engine management.
Front driver side of the crankshaft pulley.
on the drivers side by the injector pump
It doesn't have a mass airflow sensor.
A 2000 Dodge Ram diesel does not have an oxygen sensor.
On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.