• Auto Parts and Repairs
  • Search Engine Optimization
  • Search Engines
  • Google

Where is the computer in a 4wd 1985 Chevy S10 Blazer 2.8 engine?

Top Answer
User Avatar
Wiki User
Answered 2004-10-22 12:52:30

It should be behind the left or right kick panel (chances are passenger side). The kick panel is right in front of the door, under the dash and beside your foot if you're sitting in the vehicle.

User Avatar

Your Answer


Still have questions?

Related Questions

What is the towing capacity of a 1985 Chevy S-10 blazer with a 2.8 liter engine?

not much. probably doesn't tow the blazer that well

Where is power steering reservoir on 1985 Chevy blazer?

Its mounted on pulley system on t besi he front of the engine opposite the alternater for k5 blazer 1985 an in the same place from 79 to 87 years

Gapping sparkplugs for 1985 Chevy Blazer?


Overall length of a 1985 Chevy Blazer?

The overall length of a 1985 Chevy Blazer is 4,712 mm or 185.5 inches. Its curb weight is around 2075 kg.

Where is the fuel pump located on a 1985 Chevy blazer K5?

Standing in the front of the engine, it will be on the left bottom side of the engine block up towards the front.

Can you put a 350 Chevy engine in a 1985 s10 blazer without changing transmissions?

No, you can't. transmissions bellhousing is different in 60° V6 and L4

How much fuel does a 1985 Chevy k5 blazer hold?

24 gal

How do you add transmission fluid to a 1985 Chevy Blazer?

Through the filler pipe at the right rear of the engine. Check it when hot, with it on level ground and don't overfill it

Where is the Fuel pressure regulator located on a 85 Chevy S10 Blazer 4X4?

The 1985 Chevrolet S 10 blazer fuel pressure regulator can be found on the top of the engine. The fuel pressure regulator will be near the fuel injector pump.

Why is your battery steaming in your 1985 Chevy Blazer?

check your regulator. it maybe over charging your battery

What is the correct tire pressure for a 1985 Chevy Blazer?

no one its just dum dum dum

Where is the electronic control module on a 1985 Chevrolet S10 Blazer 2.8 engine?

There is no ECM in the 1985 S10, it is carbourated.

What is the curb weight of a 1985 Chevy S-10 blazer?

The 1985 Chevrolet S10 Blazer has a curb weight of 4,462 pounds. The standard fuel tank capacity for this vehicle is 24.83 gallons.

Can you put a Chevy 350 in a jeep?

I have a Chevy 350 from a 1985 blazer in my 1990 wrangler. So yes it is. I also have the transmission and transfer case from it in my jeep to.

What is the curb weight of an 85 Chevy Blazer?

The curb weight of the 1985 Chevrolet Blazer is listed as 3760 pounds. The curb weight does not include any fluids or accessories.

Serpentine belt digram for 1985 Chevy Suburban?

What engine do you have ?

What type of brake fluid goes into a 1985 Chevy s-10 blazer?

dot 3 or 4

Is it possible to put fuel injection on a 1985 Chevy S10 blazer?

It already has throttle body fuel injection.

What is the wheelbase for a 1985 S10 blazer?

what is the wheel base for 1985 s10 blazer

Where is the tail lights fuse located on a 1985 Chevy Blazer S-10?

The 1985 Chevrolet have blazer tail light fuse can be found in the fuse box. The fuse box is located beneath the drivers side dashboard.

Will a 1985 400 Chevy small block engine fit in your 1989 Pontiac formula?

Yes, but Chevy did not make a 400 in 1985. If the car already has a v8, it is already a Chevy engine. If it is a v6, it is still a Chevy engine, but you would need v8 wiring, brackets, exhaust,etc to make it work.

Where is number 1 on the coil located at for a 1985 Chevy blazer s-10 2.8 L?

Number one in the distributor cap is the one closest to the front of the engine on the passenger side of the car. The number one cylinder on the engine is also in the front of the engine on the passenger side.

How do you replace the serpentine belts in a 1985 Chevy s-10 blazer?

Push the tensioner down and remove belt

What engine did a 1985 Chevy 2500 have?

Most likely a 5.7 (350cu/in)

What is the plug gap on a 1985 Chevy 305 v8 engine?