0
If you're referring to the PCM (or the electronic control module) it is located under the overflow radiator fluid tank to the driver side of the engine compartment. remove the overflow tank and the cruise control module, then that long brace. under the brace is a 'black cover' and towards the back of the vehicle is a big clip. unsnap the clip and lift the cover off - the ecm is right there! disconnect the battery before doing anything with the ecm though or damage could result to your vehicle, the ecm, or both!!!
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What is the location of the vss speed sensor wire in a 2000 Chevy venture?
Computer
Where is the alternator located on a 1999 Chevy Venture?
on my 2000 Chevy Venture, it's the one that sits pretty much on the top of the belt drive.
Show a picture of where the oxygen sensors are located on a Chevy Venture 2000?
There are no pictures on WikiAnswers.
Where do you find the spare tire on a 2000 Chevy venture?
Its located underneath the van in the rear.
Where is the horn located on a 2000 Chevy Tahoe?
I've got a better question, why is this question in the Chevy venture forum ?
I need a Fuse Diagram for 2000 Chevy Venture?
The fuse diagram for a 2000 Chevy Venture is located inside the car owner's manual. The diagram is also available at various auto part stores.
Where are the o2 censors for 2000 Chevy Venture?
The oxygen sensors on a 2000 Chevrolet Venture are located on the catalytic convertor. There are 2 of them. One is at the head of the convertor and the other is aft.
Where is the PCV valve located on a 2000 Chevy venture 3.4L engine?
mine is in the glove box.
Would rims from a 2000 Chevy Venture fit a 2003 Chevy Venture?
Yes
Where in 1998 Chevy Venture cabin filter located?
On 2000 it is in the rear of glove box --perhaps the same
Why wont your 2000 Chevy Venture start?
Something is wrong with your 2000 Chevy Venture. Better information get's better answers.
How do you reset the fuel pump on a 2000 Chevy venture?
There is no reset switch. The fuel system is computer controlled with relays.
