you would have to look up your specific model on a website like autozone. on my 97 lumina, the sensor is 18.99. where it will cost you, unless you replace it yourself, is labor at the shop.
ive had mine estimated at 150$
I was just quoted $200 for a crankshaft sensor replacement in a 1998 Chev Lumina.
There is only one crank sensor fitted, you may also have a cam sensor. the crank sensor is located either around the bellhousing or around the front crank pulley. It either has 2 or 3 wires. It picks the signal off the revolving crank so look for a sensor in the block near flywheel.
Crank sensor goes through the top driver side of the bell housing. Cam sensor is inside the distributor.Crank sensor goes through the top driver side of the bell housing. Cam sensor is inside the distributor.
Probably a crank sensor
To determine if the crank sensor is faulty on a Chevy Lumina Z34, you can perform a diagnostic test using an OBD-II scanner to check for any trouble codes related to the crank sensor. Additionally, you can use a multimeter to measure the sensor's resistance and voltage output to see if it falls within the manufacturer's specifications. If the sensor is not providing accurate readings or if there are no signals detected, it is likely that the crank sensor is defective and needs to be replaced.
The crank sensor is located on the top of the bell housing on the drivers side.
How much will it cost to replace a cank sensor on a Mazada 626?
could cost anywhere from 20 to 40 dollars
Just cost me £115, don't know if that's reasonable or a rip off
At autozone, they are $34.99.
I had the same issue with mine...it was the crank/fuel sensor...cost - 50.00 for part
400 Dollars ..it is located in the same area where the timing chain is..and cover has to come off
Just had this done on my 97, along w/ other work. It cost me around 325.00 for the crank sensor.
It does not have a crank case sensor.It does not have a crank case sensor.
A 1995 blazer does not have a crank sensor. SORRY
That year did not have a crank sensor.
3.1L dont have a crank sensor
No, there is no fuse for the crank sensor