Where is the O2 sensor on 1993 Toyota Mr2
Where do I put the transmission fluid in a 1996 Toyota t100
where is the knock sensor on a 95 Toyota t100 v6
yes
engine coolant temp. sensor
Two, one before the cat, one after.
To remove the speed sensor from a Toyota T100, first, ensure the vehicle is parked on a level surface and the ignition is off. Locate the speed sensor, usually found on the transmission housing. Disconnect the electrical connector and remove the retaining bolt or screws securing the sensor in place. Finally, gently pull the sensor out from its housing, being careful not to damage surrounding components.
To release the spare tire cage on a 1996 Toyota T100, first locate the spare tire hoist mechanism, which is usually found beneath the rear of the truck. Use the provided crank handle, often stored with the jack equipment, to lower the tire. Insert the handle into the hoist mechanism and turn it counterclockwise until the tire is fully lowered and free from the cage. Once released, you can remove the spare tire for use.
To change the oxygen sensor in a 1998 Toyota T100, first, locate the sensor, which is typically found on the exhaust manifold or downstream in the exhaust system. Disconnect the negative battery terminal and then unplug the sensor's electrical connector. Use an oxygen sensor socket or a wrench to unscrew the old sensor, and then install the new sensor by threading it in place and tightening it securely. Finally, reconnect the electrical connector and the negative battery terminal.
Under the intake manifold, right in the middle of the valley, on the block. The intake manifold has to be removed.
Yup. I've replaced and swapped out enough T100 rear ends to say for sure it will.
Under the passenger side of the truck, across from the o2 sensor closest to the engine on the muffler.