Want this question answered?
Answerthe camshaft sensor is the distributor but the crankshaft position sensor is located right next to the crankshaft its held on by one bolt
The crank position sensor is located on the front of the engine, behind the lower crank pulleys.
Hello! The crankshaft position sensor is located behind the crankshaft pulley,on the left side facing the front of the car.It is difficult to see and to remove it you need to remove the crankshaft pulley ( radiator,belts,.... )
location cranckposition sensor mazda tribute 4cyl
On most 90s Mazdas the firing is controlled by the crankshaft position sensor that sends a signal to the ignition coil telling it when to spark, on v6 models the sensor is located underneath and to the right of the crankshaft pulley on the passenger side of the car.
It's located in the engine compartment. Undernead the air filter. You can look under Throttle position sensor to view pictures of it.
It is located on the inside of the distributor . Three pin connector .
Check your Crankshaft position sensor. Located on the right of the crankshaft. Probably got damaged when belt broke.
On a 1999-2005 model Mazda Miata the camshaft position sensor is located on the valve cover towards the rear of the engine (closest to the firewall). It has one 3-pin connector connected to it and one 10mm bolt to remove the sensor
Most knock sensors are located in the block on the firewall side. Should be the only sensor with two wires in the block. It will also have a camshaft position sensor as well. Hope that helps. I am not educated on Mazda engines.
Where would the knock sensor be located on a 2004 mazda 6?
99 mazda b3000 where is the speed sensor located