Where is the crankshaft position sensor located on a 1999 Ford F150?
forward of the firewall
Where is the crankshaft position sensor located on a 1999 Chevy lumina 3.1L engine and do you have a diagram?
Where is the crankshaft position sensor located on a 1999 Oldsmobile Intrigue and how is it replaced?
There are two crankshaft sensors on 1995 and later models The crankshaft position sensor (REF) is mounted at the front of the engine on the aluminum oil pan section below the crankshaft pulley The crankshaft position sensor (POS) is mounted on the aluminum oil pan section at the rear of the engine near the transaxle bellhousing
The crankshaft position sensor is located on the engine block above the starter motor on all 4.7L V-8s. The starter motor must be removed in order to service the sensor. If your jeep is equipped with a front axel skid plate it must also be removed. The starter motor (and Crankshaft Position Sensor) are located at the rear of the engine very close to the transmission bell housing Good luck !!
1999 GST you broke a small sensor that was attached to the bottom gear-crankshaft as you were removing the tiiming belt what does it do?
On my car (1999 Escort zx2 2.0 l DOHC) it is located on the exhaust side of the engine, looking at the engine from the front to the car towards the rear, it will be on the lower right hand side of the engine, I had to drop the catalytic converter to get to it, you will feel wires and a connector on the lower right, this is your crankshaft position sensor, it (the alignment…