Cars & Vehicles
Chevy Camaro
Crankshaft Sensors

Where is the crankshaft position sensor on a 3.8 2000 Chevy camaro?

012

Top Answer
User Avatar
Wiki User
Answered
2014-09-26 16:11:38
2014-09-26 16:11:38

It is located on the passenger/right rear side of the engine, near the oil filter.

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


how do you change a crankshaft position sensor on a 1999 chevy camaro z28?


The 2004 Chevy Malibu crankshaft position sensor location is dependent upon the type of engine. In most cases the crankshaft position sensor is on the back of the engine.


No, the 1983 model does not have a crankshaft position sensor. Only distributorless engine needs a crankshaft position sensor.


The 1997 Chevy Malibu crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.



Locate crank shaft sensor 2005 Chevy aveo



Do you have a picture of location of crankshaft position sensor for 1992 Chevy Cavalier 2.2L ohv engine?



The 1999 Chevy Lumina 3.1 liter engine crankshaft position sensor is located on the back of the crankshaft. A diagram can be obtained from most Chevrolet dealerships.


The crankshaft position sensor is located right above the starter, you may have to remove the starter for better visibility.



Where is the crankshaft sensor located on a Chevy 1500 sil. turbo diesel truck?


Most likely on front cover of engine by crankshaft


You will find the crankshaft position sensor on the passengers side of the engine block, close to the starter.


way is my crank sensor over heating on my 2005 colbalt



where is the crank shaft pistion sensor located on a 2002 Chevy Malibu, and how hard is it to replace


the sensor itself is on the bottom of the timing chain cover on the left.


where is the cranksensor on 1994 chevy pickup with a 6.5 engine


It is behind the starter, Will have to remove starter to get to it.


how to tell if my crankshaft sensor is not working


The crankshaft sensor on a 1999 Chevy Blazer is located on the bottom of the engine, near the oil filter. It connects to the vehicle's computer and constantly updates it on the crankshaft's position.


It does not have one. Crankshaft position sensors are used in distributorless ignition systems to tell the ignition control module where the crankshaft is in its rotation. The 1982 thru 1986 2.8L engines had distributors so they had no need of a crankshaft position sensor.


The 1992 did not use a crankshaft sensor.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.