Chevy Lumina
Crankshaft Sensors
Ford Explorer XLT
1995-2005 Chevy Cavaliers

Where is the crankshaft sensor for a 1990 lumina?

313233

Top Answer
User Avatar
Wiki User
2005-09-18 20:22:41
2005-09-18 20:22:41

The crankshaft sensor is located on the lower part of the engine closest to the firewall, on the passenger side of the car.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Where is the crank sensor on a 95 chevy lumina car ?

User Avatar

where crankshaft sensor at?1995 Chevy lumina van v-6 3.1 i couldn't find crankshaft sensor. can u tell me where exactly is that thanks where crankshaft sensor at?1995 Chevy lumina van v-6 3.1 i couldn't find crankshaft sensor. can u tell me where exactly is that thanks

User Avatar

The 1999 Chevy Lumina 3.1 liter engine crankshaft position sensor is located on the back of the crankshaft. A diagram can be obtained from most Chevrolet dealerships.

User Avatar

That year model did not use are have a crank sensor.

User Avatar

My 1990 Lumina 3.1 had the same problem and it was caused by the crank sensor.

User Avatar

Right behind crankshaft pulley on side. Depends on the amount of clearance you have to whether it is a piece of cake or not.

User Avatar

How many crankshaft senors do a 93 lumina have

User Avatar

There is no cam sensor on a 90 3.1. Only a crank sensor.

User Avatar

Usually on most Vehicles the Crankshaft Sensor is located Behind the Lower Pulley which is known as the Harmonic Balancer.

User Avatar

My 1990 Lumina 3.1 had the same problem and it was caused by the crank sensor.

User Avatar

the o2 sensor for a 1990 Chevy lumina euro 3.1l v6 is on the down pipe for the exaust just below the manifold on the back side of the engine, by the firewall

User Avatar

how can i find where the camshaft sensor on a 1990 mercury marquis

User Avatar

sounds like the crankshaft sensor is bad

User Avatar

on most cars it in the front at the bottom of the by the crank pully

User Avatar

The crankshaft sensor in your 1990 former Roche is located on the front of the engine. The best way to test your crankshaft sensor is to hook the engine to a Dyno tester.

User Avatar

There is no cam sensor on a 93 3.1. Just a crankshaft sensor....which is located behind the harmonic balancer. WRONG! it does in Fact have a cam position sensor! its underneath the intake plenum!

User Avatar

There are a few reasons. crankshaft position sensor, faulty fuel pump, fuel pump regulator, throttle position sensor, oxygen sensor. Need to have it diagnosed.

User Avatar

Assuming that it is a 3.1 V6, as most of them are, there is no cam sensor. Only a crankshaft sensor. It is located behind the harmonic balancer. To replace it the balancer has to be removed.

User Avatar

Just had this done on my 97, along w/ other work. It cost me around 325.00 for the crank sensor.

User Avatar

on the back of the block by the exhaust manifold


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.