where is the crankshaft sensor located on a 1993 dodge intrepid
passenger side in the transmission bell housing.
the crank sensor is on the passenger side of the car on the back of the engine. Check right up there by the transmission housing.
where is the crankshaft sensor on a 1994 dodge pickup with a 5.9l engine?
It's located at the right (passenger) side of the transaxle bellhousing.
Yes, it could.
No. The camshaft position sensor and crankshaft position sensor tone wheels are different. It may fit, but the engine will not run.
if its the 3.5L the sensor is right on top, at the front of the engine. the cam sensor is near it just to the driver side of the top of the engine. The intake has to be loosened enough to get the cam sensor out form under it. The crank sensor is easier to get out.
CMP : camshaft position sensorCKP : crankshaft postion sensor.CMP : camshaft position sensorCKP : crankshaft postion sensor.
It should be on the transmission by the passenger side of car. It has three wires connected to it.
It is on the passenger side of the bell housing about half way up.
Front left of engine.
looks similar to the camshaft sensor, but it's located in the bell housing on the transmission on passenger side.
The crankshaft position sensor on a 1998 3.0 dodge caravan is located on the top of the bellhousing towards the firewall.
Front driver side of engine.
Front of engine, reads off a a tone wheel behind the crankshaft pulley.
Driver side of the bellhousing.
it's on the right front of the engine, not far from the crankshaft sensor
how to replace a map sensor on a 2004 dodge intrepid.
The 1994 Dodge Intrepid O2 sensor is located on the outside of the air cleaner housing. The sensor is on the back side of the housing.
The 3.5 SOHC engine found in a 1993 Dodge Intrepid puts out 214hp and 221ft/lb of torque to the crankshaft.
It is located on the rear of the engine, just above the oil pan. It has a three wire sensor.
The Crank sensor is located on the transmission housing near the top at the back of the engine.