answersLogoWhite

0

The ecm or engine control module aka powertrain control module is located on the floor under the dash. You can pick up used ones on ebay...

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the ecm located on a 2001 pathfinder?

ecm location 2001 pathfinder


How do I access ECM on 2003 Kia Spectra?

There's an OBD2 port on the LH side of the dash, under the steering wheel... you plug an OBD2 scanner into there.


Where is the ECM ECU on a 2000 Kia Sephia?

it is located on the floor under the stero


Where is the ecu located on 2002 Dodge Dakota truck?

Were is the ecm located on a 2001 dakota


Where is ecm located on a 2001 Honda civic?

behind the glove box


Where is ecm for 2001 Isuzu npr?

drivers side under dash to the left of column


Where exactly is the ECM located on a 2001 Infiniti i30--I looked a bit under the passenger side kickboard but did not see it?

the ECM on 2001 Infinity I30 is located at the bottom of the center console and does not require dismantleing the dashboard.


What is code P0121 on 2004 Kia Spectra?

Code P0121 on a 2004 Kia Spectra indicates a problem with the Throttle Position Sensor (TPS) circuit. This could be due to a faulty TPS, a wiring issue, or a problem within the engine control module (ECM). The TPS is responsible for monitoring the position of the throttle plate and relaying that information to the ECM, which adjusts fuel delivery and engine performance. If this code appears, it’s advisable to inspect the TPS and associated wiring for faults.


Where is ecm located on 2001 Audi tt?

ECU under Rear Seat.


Where is the ecm located on a 2001 Toyota 4Runner?

It's located behind the glovebox, up under the dash.


Will a 2001 kia Rio 1.5 engine work in a 2003 kia Rio car that has a 1.6?

Yes it will the 1.5 and 1.6 share the same engine wiring harness and ecm. It is a direct bolt in.


How do you change the ecm in a 2001 Oldsmobile aurora?

it is located under the airfilter. Remove the air box and the 2 screws holding the cables on the ECM. After the cables are disconnected you can just lift out the ECM.