answersLogoWhite

0

There is no pressure sensor. The EGR valve is located on the head next to the battery. Cleaning it is usuallu the first step if there are any SES codes associated with the valve.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you change crankshaft sensor in a 2001 Saturn sl?

were is crankshaft sensor located in 2001 Saturn l300


Where is the governor pressure sensor on a 2001 dodge ram 1500?

It is inside the trans, on the valve body on the passenger side.


Where is the accelerator pedal position sensor on a 2001 Saturn 3.0L?

There is a throttle position sensor mounted to the throttle body. That's the place where the air intake valve sits near the top of the engine. Look for the throttle butterfly valve; on the end of the butterfly valve shaft should be a little sensor with wires connected; that's the throttle position sensor.


How do you replace a transmission connector on a 2001 Saturn?

how do i replace a transmission sensor switch on a 2001 l-series saturn


On a 2001 dodge ram 2500 where is the transmission pressure sensor and governor solenoid on a 47RE?

They are inside the trans, on the passenger side of the valve body.


How do you repair egr valve on 2001 Saturn sl2?

You clean or replace it.


Where is the crankshaft sensor at on a Saturn 2001?

right below the continueum transfunctioner


Where is the low side pressure port on a 2001 Saturn L200?

The 2001 Saturn L200 low pressure port can be found on the air conditioning compressor. The low pressure port will be closest to the front of the engine compartment.


Where do you get a fuel tank level sensor for at 2001 Saturn L200?

probably the dealership


Where is oxygen sensor bank 1 sensor 2 located on a 2001 Saturn SL1?

behind the catalytic converter


Where is the intake valve timing control position sensor located on a 2001 infinity qx4the computer is throwing a p1140 code?

The 2001 Infinity intake valve timing control position sensor is located on the back and of the head. The sensor should be labeled as such.


How can obdII code 1756 on a jeep grand Cherokee 2001 be fixed?

You need to replace the governer pressure sensor, and the governer pressure solenoid. They are both located on the passenger side of the valve body, inside the transmission.