Chevy Blazer
Chevy S-10
Dodge Ram
Chevy Blazer S-10

Where is the fuel gauge sending unit on 1979 Chevy blazer?

878889

Top Answer
User Avatar
Wiki User
2004-11-23 13:29:19
2004-11-23 13:29:19

How motivated are you? First you have to drain and remove the fuel tank. You can't siphon the gas from the fill hole, there's an antitheft ball in the line. You have to get down there and take the hose off at the tank. You can siphon with a garden hose if you think gas is yummy, or they make pumps you can use, check with the parts house. The float you want is integrated with the fuel pump and return motor and fuel filter and sending unit, all in a coffee-can sized unit that unscrews and disconnects easily from the top of the fuel tank (once you have the tank all tore out, that is.) That's the good news. The bad news is the fuel unit costs around $300 by itself.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

want to replace fuel gauge with aftermarket gauge, need to keep stock sending unit, will a 230 ohm gauge work

User Avatar

305/350? 1,8,4,3,6,5,7,2 in a clockwise direction. # 1 is driver side front plug

User Avatar

They weren't known as Chevy IIs in 1979, but yes, they could have a V8

User Avatar

Most Chevy 350 4 bolt engines will bolt into a 1979 Corvette.

User Avatar

How do you install a new heater core on a 1979 chevy monte carlo?

User Avatar

Faceing the engine its under the dis-cap on the right side. It is also very hard to get to, I advise the help of a profesional tech to change.

User Avatar

The Chevy Chase National Humor Test - 1979 TV was released on: USA: 10 May 1979

User Avatar

www.usedpartscentral.com/used_chevrolet_parts.htm and www.ebay.com are two places where you should be able to find a seat for your 1979 Chevy.

User Avatar

It comes in handy to know the weight of a vehicle. The 1979 2500 Chevy pickup has a curb weight of 6,236 pounds.

User Avatar

what is stock differential ratios for a 1979 gmc jimmy

User Avatar

The weight of a 1979 Chevy Silverado camper special with a 400 tyranny is about 3,342 lbs. In the years 1973-1979 the truck weight did not change.

User Avatar

either its running to lean or you have a bad exhaust valuve

User Avatar

In 90%+ condition about $700 for a 20 gauge and about $550-$600 for a 12 gauge.

User Avatar

its in the fuel tank must drop the tank to get to it

User Avatar

Check out this site, http://www.nadaguides.com/

User Avatar

it is on passenger side toward tranny

User Avatar

This is the block casting number for a Chevy 305, build between 1976 and 1979.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.