answersLogoWhite

0


Best Answer

Inside the fuel tank in the top, with the fuel pump.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the fuel level sending unit located on a 2005 Chevy Malibu?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the fuel level sensor located in a 2001 Chevy Suburban?

It is inside of the fuel tank, and mounted on the fuel pump sending unit.


Where is the 2000 Chevy astro gas float located?

The only 'gas float' on a 2000 Astro van is part of the fuel level sending unit, located inside of the fuel tank.


What year did Chevy come out with the Malibu?

The Malibu began as a trim-level of the 1964 Chevrolet Chevelle, but became its own model line in 1978.


What does po463 code mean on a Chevy Malibu?

on 3.1 it is--- fuel level sensor-A circuit high input.


Where is the radiator cap located on a 2003 Chevy Malibu?

no cap, there is only a cap on over flow coolant tank. to add coolant add to tank make sure it is at the right level when cold.


How do you you check transmission fluid on a 2010 Chevy Malibu?

Unscrew oil level fill plug. Fluid should be level with bottom of plug


How do you check the transmission fluid on a 2010 Chevy Malibu?

Unscrew oil level fill plug. Fluid should be level with bottom of plug


2002 Chevy Malibu no heat?

Will water in your 2002 Chevrolet Malibu cooling system will result in no heat. The water level is too low to reach the heater core.


What engages fans in 2000 Chevy Malibu?

The fans on a 2000 Chevy Malibu engage when it reaches a temperature threshold around 200 degrees. It then brings the engine temperature down to an acceptable level before it is again shut off.


Why does low level coolant light stays on 1999 Chevy Malibu?

if coolant is ok!! then check coolant sensor.


Where is fuel level sensor located on 2007 Malibu?

Inside the fuel tank on the pump.


How do you replace the Oil Level Sending Unit on a Malibu?

The sensor screws into the side of the oil pan. You will need to drain the oil and then replace the sensor.