Want this question answered?
To reset a GFCI you need to first correct any ground faults in the circuit - or some other other fault in the equipment and/or its flexible cord and/or its plug - being protected by the GFCI, which is causing an imbalance in the currents flowing in the hot and neutral wires. Ground faults are usually caused by wet electrical equipment. Then you need to press the RESET button on the GFCI.
Shut the GFCI off at the panel breaker. You can remove the down stream load right at the GFCI. Then reapply the power and keeping your fingers clear of the wire terminals, trip the GFCI and reset it. If it stays reset the trouble is down stream from the GFCI. To trouble shoot down stream remove all plugged in devices and try a reset. If still no reset remove the hot wire in the hard wired fixture and try for a reset. If still no reset buy a new GFCI.
It seems there could be some faulty wiring in place. Why not talk to an expert? Give Hawkeye Manufacturing Inc. a call or visit us online at http://www.hawkeyemfg.com
From what this question is saying, the TEST button is doing its job - it is testing ( = checking) that the GFCI is working correctly.After you have tested the device by pressing the TEST button you should be able to press the RESET button again - and DO NOT PRESS THE TEST button again - and everything should work.Either your GFCI is bad [in which case replace it] or it is working perfectly.It is probably working. My sister had a similar problem. She just kept resetting until it held, but every time she got in her hot tub she got shocked.Luckily she wasn't killed. It turned out to be the fly weights shorting out against the capacitor wires, turning the water into the hot leg. Don't mess around with this kind of problem.Think about this question, read it word for word! Again we are asked to answer somebody's homework question...OR if it is a real question, you have a problem and should call a professional licensed electrician.These are devices that protect you and your family - if you have to ask how to fix one, this is not a DIY project!As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.Before you do any work yourself,on electrical circuits, equipment or appliances,always use a test meter to ensure the circuit is, in fact, de-energized.IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.
there should be 5 wires, hot and switched hot for the switch and hot, neutral and ground for the gfci receptacle.
The hot springs out of Whakatane, and South of Rotorua are :: The Awakeri Hot Springs The hot springs out of Whakatane, and South of Rotorua are :: The Awakeri Hot Springs
Any electrical meter which measures volts or a standard plug tester. (the ones which plug into the receptacle and light up indicator lights) As long as the receptacle measures 110-120V between the hot and neutral, and measures 110-120V between the hot and ground, then it is wired correctly and supplying correct voltage with ground reference. To determine if the GFCI is "tripping" or opening the circuit when it should, simply press the test button. If it doesn't trip, (or reset correctly with the reset button) replace the device.
The address of the Hot Springs Public Library is: 2005 Library Drive, Hot Springs, 57747 1631
The address of the Hot Springs Branch Library is: 88 Bridge St, Hot Springs, 28743 M
Glenwood Hot Springs
The address of the Larue-Hot Springs Museum is: Po Box 220, Hot Springs, MT 59845-0028
there are not springs in springs they are hot steam which can be used for renewable energy