The injection pump crank sensor is internal to the injection pump. It is not serviceable.
It is located under the injection pump but you may have to pull the pump to get it it a tight fit It is located under the injection pump but you may have to pull the pump to get it it a tight fit
If equipped, it is below the injection pump.
In the timing cover behind the VP44 injection pump.
Cummins (OEM) 12 valve (single wire) oil pressure sensor is located below the injection pump and could be in front of or behind injection pump support bracket. The location was determined by the factory installing the engine. Cummins (OEM) 24 valve (three wire) oil pressure sensor is located below the ECM.
Below the injection pump, on the back of the timing cover.
Left side of engine block, below the injection pump and behind the power steering pump.
Cam sensor on a 2006 Dodge Cummins is found just below the fuel injection pump. It is attached to back of the timing gear housing. It is attached with an Allen head bolt.
It is below the injection pump on the back side of the front cover.
It is on the left side of the engine. Follow the fuel lines and you will find it.
It is in the rear of the timing cover below the injection pump and above the vacuum pump.
It is below the injection pump, in the back of the timing cover.
A chip or programer, but get a FASS fuel system first it will save you injection pump one day.