is on the transmission
It is the two wire sensor on the same side as the cooler hoses, closest to the engine.
The input and output speed sensors are located on the front of the trans. They have two wires and the input sensor is closer to the engine.
The abs wheel speed sensors are at each wheel bearing. The transmission has an input and output speed sensor mounted on the front of the transmission case. The vehicle speed signal comes from the transmission computer via the output speed sensor.
On the driver side of the transmission case there are two sensors that have two wires going to them. The input sensor is the one closer to the front.
I have a 1999 sebring and i had to replace my speed sensor. there are two sensors one located on the transmission that's the internal one and the other one is just off the drivers front wheel well, you have to pull the tire off.On the transmission, there are two,one input and one output. If the speedometer operation is the problem the output sensor is the problem is located on the driver (Left)side of the transaxle.
It is on the front of the transmission, between the cooler hoses.
There are two sensors located on the driver's side of the transmission. there is an input and and output sensor. You can get to them from the underside of the car.
It is in between the cooler hoses on the front of the transmission.It is in between the cooler hoses on the front of the transmission.
There are two speed sensors, an input and output. They are located on the transmission. If the problem is the speedometer not working it is the output sensor located on the driver side of the rear of the transmission.
It is a sensor on the transmission that reads the rotational speed of the input shaft.It is a sensor on the transmission that reads the rotational speed of the input shaft.
They are the two wire sensors on the front of the transmission case. The input is closer to the engine.
Where is my veh.speed sensor input location
Trouble code P0113 means:Intake air temperature circuit high input
yes the have a speed sensor a input and out put the input allow your transmission to change gears and the output speed sensor allow your speed to register on your speed domitor
The transmission computer uses it to know the rotating speed of the input shaft.
it is on the transmission. It is basicly under the air cleaner box. the input and output sensors are located here they both are attached by one bolt each and one elctrical connection. The input sensor in nearer the front of the car and the output about 7 inches behind the input sensor.
What this trouble code means that the input power(+) to the speed sensor is low.
There is no input speed sensor. The output sensor is located on the driver side rear of the auto trans case.
No there are no timing marks. The engine controller controls the ignition timing the input sensor is the knock sensor.
There isn't a vehicle speed signal wire on a 2007 Sebring. The transmission computer uses its input and output sensors to factor vehicle speed. It then transmits that message over the communication wires of the vehicle.
They are the two wire sensors screwed into the front of the transmission case. The input is closer to the engine.
On top of the transmission
The sensor is located on top of the transmission, and should be easy to unscrew. It is recommended that you change both input and output at the same time.
P0731 is 1st gear incorrect ratio. P0715 in the input speed sensor.Check the Input and output speed sensor located on the transmission. One or both are faulty. Input in on top towards torque conveter the output towards the end or driver side of transmisstion.
The 2001 Pontiac sun fire speed control sensor is located on the front passenger wheel. The sensor can be found on the inside of the rotor.
The year, make, model, engine info and exactly which sensors you are looking for would help.