Taken from similar answer on this site. Most of them have the orig locking code on a piece of tape located on the underside of the rear lift gate - most of the time just to the right of the latch. On my 1994 Villager the code is printed under the panel of the center console- where the radio,a/c,ashtray, etc. I had to remove the panel on the driver side next to the floor and it was printed on a piece of tape in there. Good Luck!
The 1993 Mercury Villager does not come with a factory-installed keyless entry system, as it was not a common feature for vehicles of that era. However, aftermarket keyless entry systems may be available for installation. If you're considering adding keyless entry, it's best to consult a professional installer for compatibility and options.
On a 1996 Mercury Villager, the keyless entry code is typically found on a small sticker located inside the driver's side door frame. You may need to open the driver's side door and look for the sticker on the B-pillar or near the latch area. If the code is not there, it may also be found in the owner's manual or by contacting a Ford dealership for assistance.
One way would be to take the VIN number to a Ford dealer, they would be able to tell.
The programming button for the 1997 Mercury Villager is typically located on the driver's side, near the driver's door or under the dashboard. It may also be found on the keyless entry module, which can be accessed by removing a panel near the steering column or the driver's side footwell. If you have the owner’s manual, it can provide specific details on its exact location.
Keyless entry will have a keypad built into the driver's door handle.
Villagers can have keyless entry, either from the wireless fob, or a 5 key entry pad on the driver's side door. Both require programing from inside the car by following the owners manual, as it requires several steps requiring the ignition key and other operations to involved to list here.
the keyless entry code is inside the cover in the back where the rear windshield washer container is
its on a little card in the glove box
The keyless entry code is located below the driver window on the exterior
where is the keyless entry code for a Lincoln twoncare located for a 2003
In a 2001 Mercury Sable, the fuse for the keyless remote is typically located in the under-dash fuse box, which is found on the driver's side of the vehicle. You can identify the specific fuse for the keyless entry system by consulting the fuse diagram located on the cover of the fuse box or in the owner's manual. Look for a fuse labeled for "keyless entry" or similar. Always ensure the vehicle is turned off before checking or replacing any fuses.
where can i find the master keyless entry code for a 2007 lincoln mkx