0
What else can I help you with?
How do you replace the crankshaft position sensor in the Ford Expedition 2001?
The sensor is under the a/c compressor. loosen the four 10 mm bolts for the compressor and slide it aside. Then you can remove the 5/16 bolt for the sensor and remove it.
What is the torque spec to knock sensor 3vzE?
The torque specification for the knock sensor on a 3VZ-E engine is typically around 14-16 ft-lbs (19-22 Nm). It's important to consult the specific service manual for your vehicle to confirm these values, as they can vary slightly based on the model year and application. Always use a calibrated torque wrench for accurate measurement during installation.
Where is the data link connector on a 1998 Ford Laser?
The data link connector (DLC) on a 1998 Ford Laser is located under the dashboard, near the driver's side. It is typically found above the brake pedal, close to the steering column. The connector is a 16-pin plug that allows for diagnostic tools to interface with the vehicle's onboard computer system.
What are the release dates for Video Knock Out - 2012 Reflect 1-16?
Video Knock Out - 2012 Reflect 1-16 was released on: USA: 17 September 2012
Does the 1990 Ford Laser GL have the same engine as the 1992 GL?
hai iam manu i haVE A ford laser gl 1992 model in 1990 model for laser engine is different from that of 1992 gl model its engine is quite new the engine is mazda b platform engine with 16 valves but the old engine has only 8 valves so that the performance figure is different compared to the old drivetrain has also been immproved simultaniously a lpt. they are different series engine no similarities
Where was the laser invented?
In A HouseThe first optical laser was demonstrated on May 16, 1960 by Theodore Maiman at Hughes Research Labs.
When did Theodore Maiman invent the laser?
Theodore Maiman invented the first working laser on May 16, 1960. His invention marked a major breakthrough in the development of laser technology.
What is the cylinder head and cam retaining bolt torques for a 1989 Ford Laser 1600?
For a 1989 Ford Laser 1600, the cylinder head bolts should typically be torqued to around 70-75 ft-lbs (95-102 Nm) in a specific sequence to ensure even pressure. The camshaft retaining bolts generally require a torque of about 12-16 ft-lbs (16-22 Nm). Always consult the vehicle's service manual for the most accurate specifications and torque sequences.
Is it 16 dollars for each person at laser quest or is it for eveyone?
It depends where you are going
Will 16 inch rims from Ford Explorer fit on 16 inch rims on Ford Escape?
Will they fit
When did Henry Ford created Ford?
June 16 1903
Where is the icp sensor located on a 2007 ford f250 6.0L?
on top of the passenger side valve cover, just behind/underneath the alternator. 1 1/16'' deep-socket socket to remove
