Chevy Silverado
Chevy Trucks and SUVs

Where is the knock sensor on a 1994 Chevy silverado 5.7?

567

Top Answer
User Avatar
Wiki User
Answered
2010-03-12 18:54:40
2010-03-12 18:54:40

It is screewed into the side of the engine block on the passenger side just in front of the starter.

123
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


I don't think Chevy changed the location of the knock sensor. On my 1994 4.3 its on the left hand (drivers side). There are 2 sensors there, one of them is the temp gauge sending unit and the other is the knock sensor.


A MAF sensor was not used in 1994. It don't have one.


If your refering to the engine knock sensor, it is moounted in the side of the cylinder head and has a single wire connector. try not to damage it when removing, it is a piezo electric device and is vulnerable to impact.


The 94 model does not have a MASS AIR FLOW SENSOR.


The vehicle speed sensor, on your 1994 Chevrolet Silverado pickup truck, is located on the back of the transmission. The speed sensor is labeled as such.



It is screewed into the side of the engine block just in front of the starter. It will have an electric wire pluged into it. It is round in shape.


It is screewed into the intake manifold right beside the thermostat housing.


what is the bolt pattern for a 1987 Chevy silverado


I bought a preformance chip and needs to be hooked up to the MAF/IAT sensor. Not able to locate on my 1994 Chevy silverado 5.7


I don't believe a 1994 Ford Explorer has a knock sensor - OBD I / EEC IV system


The starter relay on a 1994 Chevy Silverado is mounted on the starter. The starter and relay are usually changed as a single unit.


Unfortunatly there isn't one. I am actually looking for an aftermarket oil level sensor to install in my 1994 silverado.


1234567890111111111111112222222222234343558945894859485948594


The Manifold ?æAbsolute Pressure sensor is located on top of the manifold. It is just forward of the intake manifold and held in place with a bracket assembly.


no,it wont.they are different sizes.just order it off of the internet.


On the exhaust system before the catalytic converter. It looks similar to a spark plug with a wire out the top.


There is no knock sensor on a 94 4L jeep engine. In 1991 when they changed to the 4L HO motor, they removed the knock sensor from the system.


I have 1999 chevy Silverado z71 wanting to see if a 1994-95 chevy Silverado z71 bed will fit


it could but you might need to trim the rear a little


The knock sensor on a 1994 Lincoln Mark 8 is located on top of the engine, near the upper radiator hose. It constantly monitors for the distinctive knock made from incorrect ignition timing.


The first year of a knock sensor on a 4.0 liter OHV was 1996 ( OBD II / EEC V )


will a 2004 tailgate fit a 2006 Chevy


No. Different control mechanisms completely.


most 88-98 Chevy pickups are basically the same. the only difference between yhe cheyenne and silverado is the trim.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.