0
The knock sensor on a 1999 Toyota 4Runner is located on the engine block, typically on the driver's side, near the intake manifold. It is usually positioned beneath the intake manifold, making it somewhat difficult to access. To reach it, you might need to remove the intake manifold or other components that obstruct access. The knock sensor is a small cylindrical component that detects engine vibrations to help adjust ignition timing.
What else can I help you with?
Where is knock sensor on 99 pathfinder?
Where is the knock sensor for a 99 pathfinder
Where is the knock sensor on a 99 silverado 4.3l?
where is knock sensor located on a 99 Silverado 1500 4.3
99 Toyota 4runner replace rear speed sensor rotor on the axle?
remove the 10mm bolt and remove it.disconnect plug at other end.
Knock sensor 99 Ford Expedition 4.6l windsor?
The knock sensor is in the lifter valley
How do you change a 100 amps fuse in the engine compartment fuse block on a 2005 Toyota 4Runner?
Im having problems removing the A100 fuse from a 99 Toyota 4runner from behind the battery
What are the torque specs for the lug nuts on a 99 Toyota 4runner?
70 - 80 ft. lbs.
Where is the knock sensor on a 1999 Chevrolet Malibu?
Were is locate the snock sensor of chevi malibu 99
Where is the knock sensor on a 99 GMC sierra with a53 liter?
knock sensor location is under the intake manifold you have to remove intake their is two knock sensors front and rear
Location of knock sensor for Honda CR-V 99?
The knock sensor for a Honda CR-V 99 is located on top of the engine, under the intake. It is right beside of the number one cylinder.
What is a shape of 97toyota Camry knok sensor?
Check this out: http://cgi.ebay.com/ebaymotors/91-94-95-96-97-98-99-Toyota-Camry-Celica-Knock-Sensor_W0QQcmdZViewItemQQhashZitem51914a26aeQQitemZ350329906862QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories
Location of knock sensor on a 99 Mercury Villager?
It is under the intake manifold.
Knock sensor location for 99 alero?
On a 1999 Oldsmobile Alero, the knock sensor is located on the engine block. It may be bolted to the intake manifold, or to either side of the block.
