It should be on the drivers side of the car, under the hood, on the firewall
The master cylinder is located low, on the bulkhead (firewall) You can see it if you look under the hood, but you have to look carefully if you aren't familiar with it. It's very difficult to add fluid to it without a long funnel.
master cylinder on the gearbox vr6
On the firewall next to the brake master cylinder.
Hi The master cylinder in the odyssey is where the break fluid tank it located under the tank
Most ABS actuator pumps are located either on the master cylinder or the firewall right below the master cylinder. Either case, follow the hydraulic line from the master cylinder until you find the actuator.
Master Cylinder for brake and clutch are located next to the ABS unit on the firewall of the driver side in the engine bay. Slave cylinder for clutch is located on the bottom of the transmission.
If you need to replace the slave cylinder it is located in the bell housing and the trans has to be removed. The clutch master cylinder is located on the firewall on the drivers side
It's located on the right side of the engine bay.
If it does not have a Hydraulic clutch, then it has no fluid. If it has a Hydraulic clutch the clutch master cylinder is normally located on the firewall, driver's side, near the brake master cylinder.
The clutch gets its fluid from the master brake cylinder reservoir. The master clutch cylinder sits just below the master brake cylinder reservoir and is fed fluid by gravity.
It's on the master cylinder on the firewall. If you do not know what a master cylinder is do a google on it and get some pics.
Drivers side, near the brake master cylinder, Look for a cap that screws on.