0
Driver side, front.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Location of number one piston 350 Chevy?
Driver side front cylinder.
How do you check wiring on 85 Chevy distributor 350 engine?
Remove from engine and use an ohm meter on the ends
What do the timing marks on a 78 Chevy 350 mean?
The timing marks can assist a mechanic in setting the engine timing. The number one timing marks will set the number one piston so that the number one valve can be properly adjusted.
What side is the number one piston located on a 350 lti camaro?
front drivers side
What does the arrows on a Chevy 350 piston mean?
The arrow would normally indicate the front.You said arrows... Is there more than one arrow on the piston in question? What kind of piston?Anyway, a stock or stock replacement piston usually has one arrow or a little notch in it and that is to indicate the front.
Where is the number one and number three located on a 1977 Chevy 350 distributor cap?
18436572
How do you set timing on a goodwrench 350?
The ignition timing is set on a GM Goodwrench 350 engine by bringing the number one piston to top dead center. The distributor rotor is then pointed to the number one piston, a timing light connected, and the rotor turned until the correct timing is reached.
Where is the number one spark plug on a Chevy 350?
front driver side
What is the 350 Chevy number one cylinder and what is the number one on distributor cap?
Number one cylinder is located driver's side front of engine. With the # 1 piston at TDC on the compression stroke, the rotor will be pointing at #1 plug on cap.Number one cylinder is located driver's side front of engine. With the # 1 piston at TDC on the compression stroke, the rotor will be pointing at #1 plug on cap.
Placement of the number one plug wire 88 Chevy 350?
check out this link
Which side is number one on a 350 Chevy?
left front... ( the engines left not yours)
When timing a 350 engine does the distributor point to the number one piston or the number one spark plug?
Yes the rotor should be pointing to the #1 cylinder when you are installing the distributor.
