answersLogoWhite

0


Best Answer

Bolted on the very bottom of the engine. It is the large pan with lots of bolts around the edge holding it on. I will have one drain plug.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the oil pan for your Ford Taurus?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How much should it cost to change a oil pan gasket on a Ford Taurus?

The approximate cost to change an oil pan gasket, on your Ford Taurus, is $125. The oil pan gasket can be purchased for $10.


How to replace oil pump on 96 Ford Taurus?

You must remove the oil pan.


Where is the drain plug in a 1988 Ford Taurus?

rear side of oil pan


Where is the oil pump on a 2004 Ford Taurus?

The oil pump is bolted to the bottom of the engine , INSIDE the oil pan


90' Ford Taurus where is the oil pump located?

It is located in the oil pan. Fairly big job to replace.


Where is the oil drain pan on a 1996 Ford Taurus sho?

At the bottom of the oil sump, which is at the bottom of the engine block.


What size transmission pan in a Ford Taurus?

The size of a transmission pan in a Ford Taurus is usually 5/16x18. However, this may vary if you've had the pan replaced in the past.


Where can you find the oil filter on a 94 Ford Taurus?

Under the car on back side of the motor over the oil pan. Probally on the driver side.


How do you change an oil pump in a 98 Ford Taurus 3.0 V-6?

Remove oil pan and locate pump un bolt and replace with new one make sure you have a new oil pan gasket to replace it when your done.


How do you remove an oil pump from a 96 Taurus?

there is no oil pressure in my 1997 ford taurus, but the oil is full?


Why are their metal shavings in your 1996 Ford Taurus Transmission pan?

some metal in pan is ok.


How do you remove the knocking sound after we change the oil pan gasket on Ford Taurus gl 1994?

You are going to have to remove that oil pan again. You have either installed it incorrectly or left a tool in it. There is very little clearance in there and if it is not correctly installed the rod ends are going to strike the oil pan creting the knock you are talking about.