answersLogoWhite
Oil and Oil Filters
Chevy Silverado
Suzuki
Ford Expedition XLT

Where is the oil sending unit on a 2000 Vitara and how do you change it?

646566

Top Answer
User Avatar
Wiki User
2008-06-28 01:17:57
2008-06-28 01:17:57

Its on the drivers side of the motor behind the exhaust manifold. Take the manifold cover off and you will be able to see it between the 3rd and 4th exhaust pipes on the side of the motor.

1

Related Questions

User Avatar

Where is the oil sending unit on a 2000 dodge neon?

User Avatar

Do you mean the Temp sending unit, oil pressure sending unit, or fuel level sending unit?

User Avatar

Which sending unit? Oil or temperature? Or ?????

User Avatar

How do you change the oil filter sending unit of a 1999 suburban?

User Avatar

what kind of sending unit is it? fuel?,oil pressure?

User Avatar

There are several sending units in that vehicle such as the fuel sending unit, the oil pressure sending unit, the temperature sending unit. Need to know which one you want to change.

User Avatar

Lower the Gas tank. Remove the sending unit/fuel pump from the tank and replace the unit. The sending unit and fuel pump come together.

User Avatar

how to change a oil sending unit on a Chevy vortec v 6

User Avatar

I remove the distributor to gain access to the oil sending unit.

User Avatar

Drop the fuel tank. Remove the fuel pump and sending unit assy. This is incorrect, the 2000 up deville has an access plate in the trunk, pull out the mat and it will be obvious you can change full sending unit and pump through it.

User Avatar

The 2000 Dodge Caravan oil sending unit is located on the bottom of the engine. It is on the front on a six cylinder, and the rear on a four cylinder.

User Avatar

Sending unit is in the gas tank attached to the fuel pump as an assembly.

User Avatar

Temperature Gauge Sending Unit The sending unit is located in the front section of the manifold in the vicinity of the thermostat.

User Avatar

Assuming you mean the engine coolant temperature sending unit, we need to know what engine it has, it makes a difference.

User Avatar

You need to drop the fuel tank to gain access to the sending unit assembly.

User Avatar

the 3800 oil sending unit should be on the side of the block. It is screwed in right beside of the oil filter.

User Avatar

Temperature Gauge Sending Unit The sending unit is located in the front section of the intake manifold in the vicinity of the thermostat.

User Avatar

bad sending unit in tank.

User Avatar

Oil sending unit is under intake manifold, just behind the oil filter on the passenger side (difficult to see-use flashlight). Best option to change : Get everything to do an oil change, removal of the filter makes easier access.

User Avatar

The oil pressure sending unit is located on the oil filter bracket about 9 inches above the filter.

User Avatar

Are you refering to the Temperature Gauge Sending UnitThe sending unit is located in the front section of the intake manifold in the vicinity of the thermostat.

User Avatar

It is important to know the location of all the sensors within a vehicle. The Oil sending unit in a 2000 Nissan Pathfinder is on the engine block, close to the oil pan.?æ

User Avatar

Remove the fuel tank and then the sending unit. The fuel pump is on the fuel sending unit bracket.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.