0
you have or should have two oxygen sensors on exhuast pipe. one before catalytic converter and one after it.depending on which engine you have you usually can see the one closest to engine from under hood.second one " SAFELY" jack up car and look just past catylitci converter should see it easily.
What else can I help you with?
Where is the speed sensor for 2004 Mitsubishi Galant?
the speed sensor for 2004 Mitsubishi Galant is located on the front case of the transmission output shaft and speed sensor. It is approximately under the hood to the left of the engine.
Where is the upstream oxygen sensor on a 1994 Mitsubishi Galant?
On the downpipe before the catalytic converter.
Is the oxygen Sensor on a 2002 Mitsubishi Galant before or after the cat converter?
Both before and after.
Where is the camshaft position sensor located on a 1995 Mitsubishi Galant?
Inside the distributor
Do you need upstream or downstream oxygen sensor for a 2000 Mitsubishi Galant?
It should be equipped with both.
Where is the oil sensor located in the 1999 Mitsubishi Galant?
Answerit's next to the oil filter
How do you replace a crank position sensor on a 2001 Mitsubishi galant?
Where is the crank position sensor 0n a 2001 mitsubishi Galant
Where is the bank1 sensor2 oxygen sensor on the 2002 Mitsubishi Galant v6?
where is bank1 sensor2 on the 1999 Mitsubishi montery sport 3.5
Where is the oxygen sensor on a 2001 Mitsubishi Galant?
It's on the exhaust manifold right under your hood, at least it is in my 2000 Galant 2.4 L.
Where is the speed sensor of 2002 galant located?
The 2002 Mitsubishi Gallant speed sensor is located on the back of the transmission. The speed sensor will be in the right-hand corner of the transmission.
Where is the temperature gauge sensor located in Mitsubishi galant 2003?
is just ther e to the rigth side
How do you fix a P0135 q2 sensor heater Circuit Malfunction on a Mitsubishi galant 2002?
P0135 on Mitsubishi galant 2003 Definition: HO2S 11 Heater condition (Heated Oxygen Sensor Bank 1 Sensor 1) Explanation: The powertrain control module monitors the oxygen sensor heater. The computer has recognized a failure in this ciricuit. Probable Causes 1. -Oxygen sensor defective 2. -Poor connection at oxygen sensor 3. -Check circuit-fuse
