Remove the drivers side door panel (You should be able to replace/test it by only removing the lower left corner). The relay is mounted on the doors lower left corner. Small box approx 4"x3". Easily replaced.
Relay switch in door is bad, replace relay switch. Remove interior door panel and you will find relay switch.
check in the rightside kick panel on the passenger's side. I AM NOT CERTAIN BUT IT IS THERE ON THE 84 L. T. C.
Do you have to remove the window to take out the whole power window unit? Or better yet, how do you get it out???
near the ecm theres a bunch of relays mounted on the side/firewall..... the od relay has 5 pins,
Where is the circuit breaker for power window in 1990 camry?
If the window lock button is on (found on the drivers door) it will cause this to happen. Supposed to be a feature. it was not the lock botton.It was a bad ground on the relay ,power was getting to the relay ,but would not travel to back windows.Thanks For your input
it sounds like the window relay is not working or not making good connection.....had this happen on a 1990 town car i used to own........the relay on the 1990 was behind the glove box.....you could drop the box down and thump the relay and windows would start working......finally replaced relay and no more problems..........good luck
EEC stands for Electronic Engine Controls. The EEC Relay provides power to the computer.
inside door panel lots of hiden Philips screws
The 1990 Mitsubishi Montero 3.0 V6 is listed as a non-interference engine. Replace the belt every 60,000 miles.
The fuse for the computer in Mitsubishi Montero 1990 is located under the plate called fuse panel. This is where you will find the fuse.
Fuse or relay defective.