0
if it is a aod transmission it is on the transmission usually a sensor near the shift linkage .if it is a Manuel it is on the top at the shift tower.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
I have a 1990 Ford F150 with a 5spd M5 trans. New reverse light switch that works when you manually activate it but does not work with it installed in the transmission what is the problem?
sounds like a problem with the grounding on switch
How do you fix reverse lights on a 1998 F150--all fuses are good and both bulbs are good--neither reverse light comes on when going in reverse--this is a manual 5 speed truck?
When the shifter goes to the reverse position a switch is depressed to turn on the back up lights. The switch is most likely on the top of the transmission.
Where is the Location of backup light relay on 97 f150?
There is a backup light switch on the transmission.
1991 F150 with dual fuel tanks can you switch between tanks with the engine running?
Yes.
Can you by pass a neutral safety switch on a 1991 f150 truck?
Can you by-pass the neutral safety switch on a 1997 ford mustang 3.8
Where is the brake light switch located under the dash on 1991 Ford F150?
the brake light switch is located on the brake pedal, near the top. You will have to take off the cover right under the steering wheel to really be able to see it. Hope this answered your question
Where is the light switch that turns on the dome light inside a 1999 Ford F150?
its the little round dial next to the headlight switch turn the dial all the way up
How Do you change the external voltage regulator on a 1991 ford f150?
Unplug the electrical connection and remove the two bolts holding it. Reverse order to install.
Where would the brake light switch be on a 1992 Ford F150?
Under the dash near the brake pedal lever.
Where is neutral switch on 2003 ford F150?
how do i find the neutral, or clutch switch on a 2003 ford F150?
How do you hookup the solenoid switch on a F150 pickup 5.0 after replacing it?
To hookup the solenoid switch on F150 pick-up 5.0 after replacing it, first connect a voltmeter or test light to the solenoid's S terminal. Make sure the starter receives voltage at that terminal when the ignition switch is in the on position.
How do you remove the Turn Signal Switch in a 1991 F150?
Disconnect the battery. Remove the plastic trim around the steering column. Remove the screws that hold the turn signal switch to the column. Disconnect the switch from the wiring and remove it.
