No such switch. Just put the key in the ignition and turn it on, or unlock with the remote.
Jeep does not use inertia/reset switches.
Jeep does not use inertia/reset switches.
Jeep does not use inertia/reset switches.
unplug the battery for 2min
Put the key in the driver's door (from the outside), and unlock the door. That resets the security system.
The factory alarm is reset by unlocking the doors with a key or remote.
Your battery is toast, or check the pin switch under the hood.10.00 part. to reset the sec syst. lock/unlock passdoor
how i can reset the security sistem for a Pontiac 2001 grand am
Jeep doesn't use inertia/reset switchesJeep doesn't use inertia/reset switches
To reset the security system on a 2004 Jeep Grand Cherokee Laredo, first ensure the vehicle is in the "Off" position. Then, insert the key into the ignition and turn it to the "On" position without starting the engine. Wait for about 10 minutes until the security light stops flashing, then turn the key back to "Off" and remove it. This should reset the system, allowing you to start the vehicle normally.
Jeep does not use inertia./reset switches. The fuel system is computer controlled with relays.
To reset the security system on a 2002 Jeep Grand Cherokee, insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in this position for about 10 minutes until the security light on the dashboard turns off. Turn the key back to the "Off" position, then start the engine. If the system still doesn't reset, you may need to consult the owner's manual or a professional mechanic for further assistance.