On a 2001 Ford Focus : The brake fluid reservoir is used for the brake and clutch systems
See answer on "How do you change the front brake pads on a 2001 Ford Focus?" for a description of the location of the resivoir. The answer to this exact location is at the bottom of that answer.
How do you remove the brake light cover on a ford focus
my idling on my 2001 ford focus is not idling correct, tried to adjust idling but there is no screw or way to adjust why?
Fuse number 54
brake pedal light switch.
DOT ( 3 ) or DOT ( 4 ) brake fluid , according to the Owner Guide
its a 2001 ford focus 1.6 petrol
ESD-M6C57-A ("Super DOT 4" for MTX-75 transmissions or 'manual transmission' models) Source: Ford Focus 2001 User's Manual
To adjust the rear brakes on the 2001 Ford Focus ZX3, first remember these brakes are self-adjusting. Drive the vehicle in reverse and press the brake a few times to clear the lines and set the calipers. Then, stop the car. Place it in park and pull the emergency brake. Pump the brake while the vehicle is turned off. You will feel the brake peddle stiffen.
put a screw driver in the locking slot and lightly pry tab outward. be easy or you will brake the box
how do i change the alternator in my 2001 ford focus?
The 2001 Ford Focus has 16 valves.
Pop out the light with a screw driver and check if the aerial is loose and letting water in.
i had a similar prob but it was related to the brake booster. it is a cylendrical device that creates brake pressure and when deffective causes the brakes to be engadged and causes brake wear and slow gas mileage and warpping of brake drums and excessive wear of brake pads..... often over-looked.
The 2001 Ford Focus is a gas-powered vehicle.
The 2001 Ford Focus has an inline 4 engine.
The 2001 Ford Focus has a 5-speed manual.
the brake sensor for the 2001 dodge stratus is located on the inside of the car under the brake paddle.
Use a small screw driver or somthing that you can use to pry of the lense. Once you have done that you can change the light.
The 2001 Kia emergency brake can be adjusted with the emergency brake adjustment bolt. The adjustment bolt will be on the emergency brake pad.
How do you adjust the emergency brake on your 2001 S10 Chevy?
Most of the time you leave the pad that was against the caliper on and use a c-clamp.Some mechanics i know also open the bleeder screw to releave the pressure. it would work either way but, if you losen the bleeder screw fuild will shoot out. i would bleed the caliper after installing the brakes. losen the bleeder screw and have someone else push the brake and let some fluid out. tighten the screw before the brake peddel is let of off or air will be sucked in. air in a hydrolic brake system is bad!
how to replace water pump on 2001 ford focus