Ford Aerostar
Dodge Ram
Ford F-150

Where is the speed control module located on a 2000 f150 v8?

202122

Top Answer
User Avatar
Wiki User
2005-11-06 22:39:56
2005-11-06 22:39:56

The speed sensor is in the transmission, rear section, held in place by one bolt, will have a wire harness/connecter attached..check your fuse 1st

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

where is the fuse for the traction control module located on a 2000 Cadillac Seville

User Avatar

PCM powertrain control module is located on the firewall on the passenger side. it has 3 large wire connectors.

User Avatar

The 2000 Chevrolet Corvette blower motor control module can be found behind the passenger side dashboard. You will need to remove the dashboard in order to access the module.

User Avatar

The 2000 Ford Taurus body control module is located on the firewall in the engine compartment. The module will be on the passenger side, near the bottom, of the firewall.

User Avatar

were is the bcm located on a 2000 monte carlo

User Avatar

DO NOT USE EXTERNAL MODULE,COMPUTER DRIVES SIGNAL FOR SPARK & TIMING

User Avatar

The Engine Control Module (manual transmission), also known as PCM Powertrain COntrol Module (automatic transmission), is located interior under the glove box.

User Avatar

the power control module is located on the passanger side of the car above the plate where the carpet meets the dash.

User Avatar

it's located behind the headlight switch and push button 4wd control. the plastic piece just pops out to reveal the transfer case control module. good luck

User Avatar

Its located on the right side of the vehicle underneath the dash

User Avatar

The body control module or BCM is located beneath the center console. Not an extremely difficult task. This link should assist.http://www.justanswer.com/questions/2hyd2-2000-escalade-needs-replacement maximusdm

User Avatar

The 2000 Cadillac traction control module can be found on each wheel. There is a total of four traction control modules.

User Avatar

where is the ignition module located ina 2000 integra acura

User Avatar

5A. Stop Lamp Switch, (Speed Control, Brake Shift Interlock, ABS, PCM Module Inputs), GEM Module, Autolock, Air Suspension Module.

User Avatar

The rap module is located on the fire wall behind the radio of the 2000 Ford Expedition. Rap module stands for remote anti-theft personality module.

User Avatar

The ignition control module on a 2000 Blazer with the 4.3 is mounted on the same bracket that the coil is mounted to.

User Avatar

There is no separate BCM. These functions are contained in the TCM under the dash.

User Avatar

ECM can stand for Electronic Control Module, or Engine Control Module. A 2000 Oldsmobile Bravada uses a VCM (Vehicle Control Module) which controls the Engine and Transmission. VCM's are commonly referred to as PCM's (Powertrain Control Modules), or ECM's (Engine Control Modules)

User Avatar

on your 2000 Blazer the control module is located under the kick panel on the passenger side. Simply remove the plastic panel, unbolt the module with a 10 MM socket and disconnect the wiring hareness. While your there, check the wiring hareness for corrosion as this is a big problem. apply Dielectric grease to the hareness and install new control module.

User Avatar

There is no speedometer cable. MPH is calibrated using a speed sensor. If your speedometer is not working, you have a bad speed sensor module.

User Avatar

If memory serves me well I think it is located directly under the center console.

User Avatar

On my 2000 it is located inside right front fender well

User Avatar

NOT SURE ON YOUR 2004, BUT MY 2000 IT IS LOCATED IN THE CARGO AREA ON THE DRIVERS SIDE. THERE IS A REMOVABLE PANEL NEAR THE HATCH. THE CONTROL MODULE IS LOCATED JUST BEYOND IT AND HAS A STICKER WITH THE CODE # ON IT.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.