The thermostat housing is located at the engine end of the lower radiator hose.
There is no egr valve on a 1990 Mazda MPV 6 cylinder
Follow the top radiator hose as it connects to the front of the engine. The thermostat is located in that housing.
1990 Camry 4 cylinder thermostat is located off the bottom intake hose connected to the engine block.
The thermostat is located under the radiator cap. Take the cap off and there will be a little metal thing. Pull it out and there it is. The thermostat is located under the radiator cap. Pull the cap off and there will be a metal thing. Pull that out and there it is.
I replaced mine about a week ago. Follow the top hose coming from the radiator to a housing unit with 2 bolts. The thermostat is inside the housing.
To add brake fluid in a 1990 Mazda Protege, you need to locate the brake fluid reservoir and check the levels. The reservoir is located on the master cylinder for the brakes.
On a 1990 Ford Probe with a 3.0L V6 engine, the thermostat is located in the engine's coolant passage, which is typically found at the junction of the upper radiator hose and the engine block. To access it, you will need to remove the upper radiator hose and the thermostat housing. Once the housing is removed, the thermostat can be taken out for inspection or replacement.
it should be behind the waterpump, just below the thermostat
== == It's located within the thermostat housing, to the right side of the engine... follow the large rubber tube coming from the radiator and it shall lead you to the housing, which is held in place by two bolts. Warning: if you take the housing off, to replace the thermostat, be gentle with the thermoswitch, and it is also very fiddly to have the thermostat centralised on the housing when you bolt it back on.
in the tank
inside the radiator hose
The starter solenoid is located on top of the starter. It is the small cylinder attached to the starter. It is a part of the starter which can be replaced/repaired independent from the starter itself.