Both the engine temperature and thermistor for the engine management are located behind the alternator. They can both be readily accessed by removing the top adjustment bolt of the alternator, removing the serpentine belt and pivoting the alternator towards the rear of the firewall.
Under th inlet manifold, you will need to remove the alternator to gain access
..... sense water temperature?
The 1998 Daewoo Lanos typically uses a mixture of ethylene glycol-based coolant and water, often referred to as antifreeze. It's recommended to use a 50/50 mix of coolant and distilled water for optimal performance. Always check the owner's manual for specific recommendations and ensure the coolant meets the required specifications for your vehicle.
1. Water temperature sensor Intake air temperature sensor cylinder head temperature sensor exhaus temperature sensor and catalytic sensor
To install a water pump on a Daewoo Lanos, first, ensure the engine is cool and disconnect the battery. Remove any components obstructing access to the water pump, such as the serpentine belt and timing cover, if necessary. Unbolt the old water pump, clean the mounting surface, then apply a gasket or sealant as needed before positioning the new pump. Finally, reassemble all components in reverse order, refill the coolant, and check for leaks.
It is a small hose behind the motor, under the car. sometime is stoped with dirt and the water coming inside de car at the passenger side.
I had the same problem. I changed the cam shaft sensor,oxygen sensor,used "sea foam",replaced spark plugs and had it diagnosed dozens of times only to find out it was the head gasket was blown. I had no water/oil mixture,so I overlooked it. A last ditch effort to check the lifters revealed the problem. Hope this help ya.
The Temperature sensor for the computer is on top the head. The temperature sensor for the temperature gauge is located under the Thermostat housing.
The cost to replace a water pump in a Daewoo Lanos typically ranges from $300 to $600, depending on labor rates and parts availability. This estimate includes both the cost of the water pump itself and labor charges, which can vary by location and mechanic. It's advisable to obtain multiple quotes from local repair shops for the most accurate pricing. Additionally, if other components need replacement during the service, such as the timing belt, costs could increase.
It depends on the engine:- SOHC Cylinder head underneath the ignition coil. DOHC Cylinder Head under underneath the intake nanifold
Thermostat probably needs replacing They can stick not allowing enough water to flow around the engine block If the engine overheats it can warp the head or blow the head gasket
Most engines have the temperature sensor either at the top water inlet or on the side of the block. Remove the sensor wiring, then unscrew the sensor to replace it.