If it is an 3.7L or 4.7L engine it is on the throttle body mounted on the side. If it is a hemi engine there are two throttle position sensors. The throttle body is electronic. There is a position sensor mounted underneath the battery hidden behind a cover. The accelerator cable goes from the gas pedal to this sensor. This sensor sends info to the PCM (powertrain control mondule). There is also another position sensor inside the electronic throttle body which tells the PCM what position the throttle plate is at. These throttle bodies on the hemi engines become dirty and cause codes like a P2175 and 2106. It will also make the ETC light flash, and cause low acceleration and limp in mode problems. Cleaning this throttle body will correct this.
The throttle position sensor is part of the throttle body and is not serviceable separately.
It is on the throttle body.It is on the throttle body.
On the throttle body, opposite of where the cable attach.
The tps is part of the throttle body and is not serviceable.
Bad Throttle Position Sensor
You don't. But you can clean the throttle body with throttle body cleaner. Just follow the directions on the can.
The throttle position sensor on a 2003 Chevrolet Suburban is located on the side of the throttle body. It notifies the vehicle's computer of the actual position of the throttle plate in relation to the throttle body.
How to replace throttle sensor kia spectra 2003
It is on the throttle body. On a 5.7L it is part of the throttle body and is not available seperatly. ON a 5.9L it is opposite the cables on the throttle body.
The Throttle Position Sensor is conneceted to the end of the Throttle Shaft inside the Throttle Body. P.S. The Throttle Position Sensor is part of the Throttle Body and must be replaced as a unit. Hope this helps ya.
It is a non-servicable part of the throttle body.It is a non-servicable part of the throttle body.
Attached to the throttle body