Remove you glove box. It should be behind it.
James drives Chevy Blazer, Dodge Ram, '55 Chevy BelAir i don't know about others.
Its called an "Intake Manifold Tuning Valve". Its function is to join or separate the two sides of the intake manifold. It has a minor effect on engine performance. It can be difficult or impossible to remove.
The 1997 Chevy 1500 throttle position sensor is located on the firewall in the engine compartment. The throttle position sensor will be in the center of the firewall.
bush auto place has this part! 937 382 2252 ask for kathy cook. she is the parts manager. she will look this up for you.
If I remember correctly it should be 190-205 degrees.
Where is the control module located on the 1983 Chevy blazer
Depending on what type engine you have, the ignition module may be an integral part of the distributor cap.
The oil pressure switch on a 1998 Chevy Blazer is on the side of the engine block. It is located above the oil filter.
it on the fire wall
Where is the horn located on a 1993 chevy blazer
Inside the bottom of the engine block.
At the left rear under the engine.
The water pump on a Chevy Blazer 4.3l is on the front of the engine. The Fan and fan shroud will have to be removed to gain access.
where is the transmission control system on a 1996 chevy silverado 2 wheel drive 5.7
The ERG valve is located on the front of the engine on a 1998 Chevy Blazer V6 4.3L. It is near the top bolted to the intake manifold.
you have to take the transmissionpan off and it is located at the end closest to the engine.
The 1997 Chevrolet blazer actuator switch is located on the firewall in the engine compartment. The switch is on the passenger side of the engine compartment.