answersLogoWhite

0

Just above the oil filter on the front of the engine block. (Very hard to get to; most people remove the oil filter and dipstuck tube to remove/replace the oil pressure switch or "sending unit.")

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Where is oil sending unit located on 1997 Ford Taurus?

For the DOHC motor look behind the dipstick tube for a single wire sensor.


Where is the temperature-sending unit for a 1999 Ford Taurus?

The temperature sending unit on the 1999 Ford Taurus v6 is on the rear of the engine. It is closer to the driver side about 7 inches down.


Where is the temperature sending unit located on a 98 Ford Taurus 3.8L?

The temperature sending unit it on the front of the engine. It is on the top just beside of the water intake.


What does the fuel sending unit look like on a 01 Taurus?

What dose the fuel sending unit look like on a 01 taurus?


Where is the fuel pressure regulator on a 2000 Ford Taurus 24 Valve DOHC Engine?

in the tank, same unit as the fuel pump, it is a bad design


Where is the oil pressure sending unit location l993 Ford Taurus 3.8 liter V6?

It is usually located next to the oil filter.


Where is the oil pressure sending unit on a 1999 Ford contour 2.5 L 155 Cid V6 DOHC?

it sits behind ac compressor on the 2.5l


Where is oil sending unit on a 2004 ford free-star?

Where is the oil sending unit on ford freestar


Where oil sending unit on 1992 Ford Ranger?

Where is the oil pressure sending unit on 1992 ford ranger


How do you change the sending unit on a 1991 4 cylinder ford ranger?

Do you mean the Temp sending unit, oil pressure sending unit, or fuel level sending unit?


2001 Ford Taurus 24 valve Where is the oil pressure sending unit?

The switch is on the back of the block near the transmission housing drivers side firewall side.


Where is the temperature sending unit on a Ford V-10 gas 6.8L Is it a true sending unit or just an on-off switch?

The temperature sending unit on a Ford V10 gas 6.8 liter is on the front of the cylinder head. It is a true sending unit and not just an on and off switch.