answersLogoWhite

0


Best Answer

diagram of a nock sensor in a 300zx 1996

User Avatar

Wiki User

โˆ™ 2009-08-26 21:06:58
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Where the nock sensor in 300zx motor?
Write your answer...
Submit
Related questions

Where is the nock sensor in a 1990 300zx?

Attached to the middle of the engine block right underneath the lower intake plenum, roughly half way between the heads.


1993 300zx sensor?

what sensor?


What motor is in the Nissan 300zx?

VG30DETT is in the 90-95 Nissan 300zx. It is a v6


Toyota 95 4runner code flashing dtc52 knock sensor?

where is the nock sensor on my 95 toyota 4runner


Can you put a 350z engine and transmission in a 300zx?

Yes my car is a 1990 300zx with a 2008 350z motor and 6speed transmission


Is the VG30DE motor in a 1991 300zx only in a Nissan 300zx or is it in any other vehicle makes and models?

I know for sure that it is also in the maxima


Where can you find a diagram for the location of the coolant sensor for a 1986 300ZX?

The 300ZX Shop Manual has one page visual for all the components, the sensor located on the drivers side just to the right side of the Distributor. Its screwed into the block near the top of the block and has two fine wires coming out of the sensor.


Where is the mass air sensor 300zx?

On the 89- 300zx the mass air flow sensor is located under the panel that is between the head lights. remove the panel and you will find the air filter box. the maf is bolted directly to the filter box


How do you locate the knock sensor on a Nissan 300zx twin turbo and is it easy to change?

The knock sensor on 90-96 300ZXs is located between the engine block and lower intake manifold. please if you want to know where anything is at on a 300ZX visit www.ttxtz.com


How do you test a Crankshaft Sensor in a 1986 Nissan 300ZX?

Using a scanner with a scope, you can view the output wave of the sensor as you crank the engine.


What type of engine does the 1986 Nissan 300zx have?

3.0 Nissan motor 3.0 Nissan motor


How much for a used Nissan 300zx twin turbo motor?

300


Why does your Nissan 300zx runs rough on start up?

mass airflow sensor of head tip sensor could also be catalytic converter


Settings on a 1993 300zx crank angle sensor?

Refer to your manual. Buy a Chiltons.


You are thinking about putting your 1986 300zx's motor in your 87 300zx but you noticed that the alternator on the 87's motor is on the right and the 86's alternator is on the left will it mount same?

yes it will still mount the same. the motor mount are the same and same place throughout the 84-89 300zx turbo and non-turbo. but you will either have to take the alternator bracket of the 86 motor and put it on the left side of the 87 motor and take the right side alternator and bracket off or run the alternator wiring to the passenger side of the car.


Where is the iat sensor located in 300 zx non turbo 1987?

i can't find the iat sensor for my 1987 nissan 300zx non turbo


Where is the knock sensor on a 1991 300zx 2 2 non turbo?

The knock sensor on Nissan 300ZX non-turbo from 1990 thru 1996 is located below the lower intake manifold on the rear of the engine block. To replace the knock sensor the upper and lower intake manifolds need to be removed. It is always best to replace the knock sensor with a new one considering its major dissasembly.


Where is the crankshaft sensor on 1990nissan 300zx?

it is on the front of the engine near the driver side intake tube


Where is Heater blower motor located in 1996 300ZX Nissan?

under passenger side


Location of spark plugs on 90 300zx?

Under coil packs, on top of the motor.


Where is the oil dipstick located on a 1986 Nissan 300ZX?

Drivers side of the car it is located in the center of the motor.


What is the end of the arrow with the nock in archery?

the end of the arrow with the nock


Where is the nock sensor located on a infiniti Qx4?

Directly in the middle of the V of the V6. It is under the intake plennum and many parts have to be removed to access the sensor. Directly in the middle of the V of the V6. It is under the intake plennum and many parts have to be removed to access the sensor.


What is the birth name of Bello Nock?

Bello Nock's birth name is Demetrius Alexandro Claudio Amadeus Bello Nock.


Is the non turbo block of a 300zx the same as the turbo 300zx?

Yes, it is only the pistons that are different to provide a different compression ratio (higher in the NA). Be careful when bolting turbos to an NA motor.