A straight-through ethernet cable.
straight-through
Lun te wajao inu behnchod
Configuring a physical router requires software like PUTTY. while configuring router on Software like packet tracer is done on CLI (i.e. command line interface).
A clock-rate is the speed at which the Serial connection sends data to another router and each connection must match the others clock-speed or a speed mismatch error will occur. For packet tracer, the clock-rate has no effect.
You don't. Packet Tracer doesn't support pipes.
how to unlock the config tab in packet tracer
. Completed.
its a long process
class (its case sensitive)
42
To connect multiple routers in PacketTracer 5.2, first select the "routers" section in the bottom left hand corner. From there, you can drag two routers from the pane to the right onto the working area (the large white space on your screen). Once both routers are on the screen, click "connections" (the lightning bolt) in the lower left, and click on "Automatically choose connection type" (the first one) OR "Copper crossover" (the fourth one). You will get a cursor that looks somewhat like a taser gun. Click once on each router, and you will see a cable created between them with a red dot on either end. You can now configure and power on both routers, and they will be able to communicate. Be sure when configuring both routers that you go into the Interface section and check that at least one FastEthernet port is set as "ON", so that the routers can communicate.
Fixing packet tracer 9.9.1.3 can be done by running a diagnostic on that program. However if the diagnostic does not work, a simple restarting or uninstalling and reinstalling the program may be beneficial.
The Cisco packet tracer works by allowing students to work out different problems. While letting the students to work them out with a vast ability of using many networks at their fingertips.