They form high range mountain becuase there is no subduction zone. This is usually a good place to find regional Metamorphic rock.
A basic mountain should be formed from the collision of continental crust and oceanic crustAnswerWhen an oceanic and a continental crust collide, the heavier oceanic crust tends to subduct under the lighter continental crust. Because of the collision and corresponding compression and also because of volcanism related to dehydration and melting of the subducted plate a mountain range is formed. The Andes mountain range is a, if not the, most typical example.
A section of both continental and oceanic lithosphere
Assuming a loam soil with a bulk density of 1.4 grams/cubic centimeter (this is a typical bulk density for a loam): 25 litres = 25 dm^3 = 25 000 cm^3 25 000 cm^3 * 1.4 grams = 35 000 grams = 35 kg = 77.1617918 pounds Note that this is just an estimation for a typical soil. Different type of soils have different specific weights.
A subterranean aquifer is a typical source
An aquifer is a typical source of well water.
When a continental plate collides with another continental plate, fold mountain ranges will be created. However, there would be no volcanoes, or at least very rarely not. One typical example of this process is the Himalayas.
A basic mountain should be formed from the collision of continental crust and oceanic crustAnswerWhen an oceanic and a continental crust collide, the heavier oceanic crust tends to subduct under the lighter continental crust. Because of the collision and corresponding compression and also because of volcanism related to dehydration and melting of the subducted plate a mountain range is formed. The Andes mountain range is a, if not the, most typical example.
low melting point low density not a conductor
Yes, it is more or less typical of a specific substance.
Where oceanic crust meets continental crust and earthquakes can occur.
The density of a material is generally typical of a material. The density is it's mass divided by it's volume. So if you have something that weight 20kg and has a volume of 2500cm3 or 2.5L it's density will be 8gcm-3
The typical design of a jean jacket is to look similar to a pair of jeans, and therefore the pattern is similar to the denim pattern. Sometimes, a jean jacket can be modified with beads.
A typical value of Diesel fuel density is 0,832 g/cm3.But must be mentioned that the density may be different for each refinery.
Yes, density is expressed in mass per volume (typical units are g/cm3 and lb/in3).
a section of both continental and oceanic lithosphere
a section of both continental and oceanic lithosphere
it was similar, however it was not exactly a typical amphitheatre